SOURCE: 1995 chevy g30 van
If vehicle was left outside or in an unheated garage, there is a strong possibility that condensation has contaminated your fuel. Easiest way to check is to remove fuel filter and pour contents into a glass jar. If you see two different layers of liquid in the jar, the bottom part is water. Replace with new filter and drop the tank. Remove sending unit. pour contents into a large container and clean out inside with clean dry rags. Remember, fuel is dangerous to work with and fumes travel pretty far on the ground. So, no open flames electrical stuff, cigarettes etc for a good perimeter around work area. Generally, you can re-use top 3/4 of fuel you removed by syphon. Don't use remainder in your vehicle. Part can be used for lawnmower etc as long as you only take the part above the water line.
SOURCE: 1993 honda accord wont start on hot days after sitting for hours
THE BRAKE LAMP WAS ON THIS SATURDAY WHILE I WAS DRIVING.SO ON SUNDAY WHILE IT WAS RAINING I PARK IT UP BY MY HOUSE AND THEN WHEN I WAS COMING OUT SIDE TO START THE CAR WOULD NOT START KEEP ON TURNUNG BUT NO START FINDLY AFTER AFTER ABOUT 2 MIN IT DECIDE TO START BUT THE HOLD THIS THING IS WHEN THE CAR WAS IN THE HEAT AND SITING THERE IT START
SOURCE: car spits and sputters and stalls after driving a while
sounds like a fuel pump problem,with fuel pumps u can have pressure but not enough volume,try goin up a steeper hill in 2nd gear and get about 3000 rpms on the engine and see if it really drops out bad and is really gutless,if that happens without a check engine light coming on it might be yur pump and u should also replace the fuel filter at the same time,hope this helps
SOURCE: 2000 Grand AM GT Shuts off while driving
What you should do is check for spark when the vehicle stalls.If you have no spark then you probably have a bad ignition module.The other thing is You didn`t mention if the check engine light is coming on.If it is then have the codes read.Even if it is not you should still check the codes.Sometimes the computer will have a code and the light will not come on.This could give you a clue as to what could be causing the engine to stall.You might also want to check your fuel pressure just to make sure it is good.The pressure should be 52 - 59 psi.Hope this helps.Good luck.
242 views
Usually answered in minutes!
×