I have a 2001 eclipse and drove to store. When I got back in it wouldn't stare. Horn or radio doesn't work either.
SOURCE: radio code Eclipse Spyder,how do you enter
Contact your local Dealership and ask for Parts. They have all the Codes and can tell you by Running your VIN Number.
SOURCE: need 4 digit radio code for 2001 mitsubishi eclipse
try to call the mitsubishi dealer coz every radio has different code thats the only way you can get those code.
SOURCE: 2001 mitsubsi eclipse enter car radio wrong code 3 times
call 1888mitsu2001, choose option #4, then hit * (star). give the
operator the last 8 numbers in your vin and they will provide the radio
code for FREE!
DO NOT PAY FOR THE CODE ONLINE OR GO TO THE DEALER (they will also charge you).
- you will also need to provide the serial and part number of your radio
(takes about 5 minutes to take apart an eclipse dash...1 screw in the
bottom of the HVAC panel) if you call the 1888mitsu2001 it will provide
basic instructions on how to accomplish this.
- if your radio says "off" (meaning you entered the wrong code too many
times) you need to put your key in the ignition and turn it to ACC mode
for approx. 45min - 1hr and then your radio will say "code" at which
point you can enter the code to unlock the radio.
SOURCE: Adjusting Headlights w/2001 Eclipse?
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
147 views
Usually answered in minutes!
×