Freeze plug location for 1998 subaru forester

SOURCE: 1998 Subaru forester repair manual, Non-existent?

Yes, all the colour codes will be the same, plus 99.9% of the rest! Frankster016

SOURCE: what does the hold signal with snowflake mean in a 1998 subaru fo

If you have the owners manual you should be able to look it up in there..if you don't have the owners manual..call your local Subaru dealer ask for the service department and ask the service tech...they're usually prettty good about that type of question.

Thanks for letting FixYa.com help

Happy New Year

SOURCE: Where is th fuel pump relay on the 1998 subaru

thew fuel pump relay will be located in the power distribution box under the hood it is a square fuse like device either black or grey in color

SOURCE: 1998 subaru forester runs rough when it rains.

Check the cap and rotor for internal carbon tracking or, just change them. Also, take a look at the coil when its dark and rainy and see if there is any arcing where the coil wire goes into it.

SOURCE: How do I change the spark plugs for a 1998 Subaru

Hello, first, you must remove the air cleaner housing Move the tube from the air cleaner and the intake on top of the engine by loosening the hose clamps at each end. It is still attached to a hose underneath but can be put out of the way

Remove the top of the air cleaner and the filter.

Remove the two 12mm bolts at each side of the bottom.

The side of the bottom is rubber gasket to the inside fender - just rotate slightly each way to loosen and pull off and put off to the side - there is still a wire attached.

Now pull off the spark plug caps on the side of the engine. This is a boxer engine which means the plugs are in a horizontal position on the sides. It is good to have a pair of spark plug pliers to do this as they are really difficult to remove. (spark plug pliers form a circle on the end when closed and are nice to grasp the caps with). Now you will need a 3/8 drive socket wrench, a 2" extension and a 5/8 deep socket Connect the extension and socket and feed it into the spark plug hole and over the spark plug. It is really deep inside. Now attach the wrench and remove the spark plug making sure you keep the tools level so as not to torque the plug side ways. Once the plug is real loose, unattached the wrench and hand loosen the plug with the extension because the wrench won't fit to remove the extension and socket attached. Remove the extension and socket and then spark plug. Put in the new plug reversing the steps.

Thanks

Testimonial: "Thnx. just what I needed to know. I need smaller hands.lol"