I have a 2000 chevy blazer s10 and the incline lever is broken

some have a limiter on them some go to a full recline for sleeping..the best way to know is look at the mechanism for fresh broken steel or plastic..at the worst .. replace the seat..

Not much your can do there & the parts
are no longer avail, after ten years or so

I have 1984 S10 Blazer, for 29 years, mine still works,
so far

Have to look at the latch to see if it is bent,loose,
etc

Your on your own there for a solution, even if the vehicle
was new

Simple device,but no real fix

Remove the door panel and inspect the latch rods for damage or broken retention clips. A video is below of how to remove the panel.

SOUNDS LIKE THE MOTOR IS GOING OUT,BECAUSE AT LEAST ITS MOVING,I WOULD REPALCE REPLACE THE MOTOR,GOOD LUCK!!!!!!!!

went to move my seat forward on driver's side and seat back flipped forward and now does not lock. What to repair?

My driver side seat back is stuck in the forward position.

usually not. seat is electric and adjusts to extent allowed by that. Passenger seat has a back release on it though.

I had the same problem - driver side fine, passenger side front not working/slow or the back seat. You need to replace the window motor on the passenger side. Yes, there are two motors. It's pretty simple if you are handy with some tools. The hardest part is getting the 4 mounts that hold the window motor to the door off. The are factory riveted to the door, so I had to grind the outsides off and tap them out. Just watch the spring lever that holds the window bar for going up and down. I didn't pay attention and it snapped back - nearly broke my thumb.

Dani-Lynn

you can replace the recline lever assy without removing the seat