This should be straightforward but I cannot find it. I have removed the plastic guard under the washer reservoir ( this is where the garage told me to look! ). I can see the water pipes leading out of the reservoir but cannot see where they go. I assume the pump is elsewhere under the bonnet. Unfortunately I cannot safely get right under the car.I chose the Accent model because a Coupe is not listed.
I suspect the pump is inside the reservoir. The link is for a Hyundai Elantra (2001-2006) and shows how to get to it for this model. Hope this helps!
How To Install Replace Windshield Washer Pump Hyundai Elantra 01 06 1AAuto...
SOURCE: how do I unjam a rear passenger seat belt from a hyndai accent 2000
i strongly recommend you take your vehicle to your vehicle's local dealer and have the belt removed from the door and then inspect the belt for damage. A damaged seat belt might break when you need it most. Seatbelts and safety are the most important thing!
Happy to help
Have a nice day!
tc
SOURCE: Hyundai Coupe V6 windscreen washer not working
It sounds as if there is a blockage either in the base of the screenwash reservoir or the feed pipe from the reservoir. You could remove the screenwash reservoir tank and clean it out and at the same time check the pipe.
Please remember to rate this solution.
SOURCE: windscreen washer won't work
the tube goes along side the apron and goes into the bottom of the washer reservoir which is behind the headlighplease rate my response thank you very much
SOURCE: windscreen washers not operating on HYUNDAI COUPE
Check to see if the screen in the reservoir is plugged and not allowing fluid to go through.
SOURCE: Hyundai Accent SI-back windscreen wiper
there is a 15 amp fuse for the rear wiper under the bonnet check this, also i think the accent has a seperste switch in the dashboard for the rear wiper like th hyundai coupe.
291 views
Usually answered in minutes!
×