Truck just wouldn't start realized no spark. Car MD says bad cam to crank position sensor so I changed cam position sensor, crank sensor, ignition module, coil, cap, and rotor. Still no spark and car MD still has same error. any ideas?
SOURCE: 1996 chevy truck 305 new rotor and distributor cap
did you test or replace the crankshaft position sensor? That is where the spark signal begins.
SOURCE: 1992 chevy blazer 4.3 vortec engine 2w dr have
Check the wireing to the pump they had problems with it it tended to over heat and corroad there is a service bulliton on the prroblem #25215705and a kit with new wires and connector to resist over heating Icould give you the kit # but i got a DELPHI pump and the connector dosn;t fit a chevy pump
SOURCE: 1989 chevy truck, 5.7...will not start....no fire
Hi, I believe there is a computer problem. If possible check codes for no start condition. if you know the no.#1 cylinder at TDC (Top Dead Center) on engine then you will know no#1 distributor is. Good luck.
749 views
Usually answered in minutes!
×