I just need to know if the wheel hub assembly can be taken out by a person or does it require a press. This is for the whole wheel hub assembly not just the wheel bearing.
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: front wheel hub assembly replacement
if you have basic knowledge you should be able to carry out this job yourself. you will probably need to ring a dealership and ask very kindly if you could have the torque settings for the nuts and bolts ect.
hope this helps.
SOURCE: replacing front wheel hub assembly 1996 Dodge caravan
first jack up the van remove the wheel remove the brake caliper and rotor remove the axel nut then remove the three bolts on the back of the hub tap on the hub with a hammer it should come out hope this is helpful
SOURCE: wheel bearing assembly 2004 dodge ram 1500
Hub & bearing should be one assy, is that what your looking at?
3 bolts behind hub, to remove, done?
SOURCE: Need to set clock on 2008 Dodge Avenger
push and hold set up until number blinks to switch to mins push tune knob
1,913 views
Usually answered in minutes!
×