Factory amps are located on the stereo unit itself or in the trunk but only if the car was ordered with premium sound and the possibilities of that car being ordered with premium sound is unlikely. so at the harness in the back of the stereo find the speaker wires and hook up a 9 volt battery to the said speakers that dont work if they crackle then its in the stereo if not its the speakers or wires to speakers with battery hooked up and speakers dont crackle go to speaker and test with a vom and test for 9 volts dc
SOURCE: 2001 Sunfire rear brake/turn signal don't work.
check your fuzes. if that doesnt do you any good maybe a flasher or check for bad wiring. maybe a short somewhere
SOURCE: needing wiring diagram for 1991 dodge dynasty le
here is what I found:
http://www.the12volt.com/installbay/stereodetail/715.html
SOURCE: 2002 Pontiac Sunfire rear brakes
Yes i fixed the problem i had to remove my backing plate and grind them smoth where the brake shoes rub on them then. I put some high temp brake grease between the shoes and the backing plate works great now!!! seems like the backing plate gets grided down by the metal from the brake shoes throug the years.. You will see the metal on the backing plate will have some ridges on them so make sure you grind them smoth
SOURCE: rear brake diagram for 1996 pontiac sunfire
take both drums off the do one whilst looking at the other in case you forget where that little spring went
SOURCE: My 1999 Pontiac Sunfire's left
Your turn signal switch in your sterring colum is bad. The turn signal canceler in the switch is bad causeing both brake lights to be canceled all the time. Common problem
500 views
Usually answered in minutes!
×