What parts need to be taken off to get to the water pump...where can i get a diagram????
1. Remove the alternator & power steering pump drive belts.
2. Remove four (4) 10mm bolts holding the water pump pullys & remove the pullys.
3. Drain the Radiator (save coolant if intend to reuse).
4. Loosen & remove AC compressor belt.
5. Remove crankshaft pully (22mm bolt).
6. Remove lower timing belt cover (10 mm bolts) to access water pump bolts.
7. Remove the water pump (12mm bolts)
(1)
Remove the 2 bolts, then remove the alternator brace (A).
(2)
Remove the water pump (B) and gasket.
8. Clean mating surface on engine & install new gasket & pump - reassemble. Refill w/50-50 coolant.
679 views
Usually answered in minutes!
×