Cars & Trucks Logo

Related Topics:

Anonymous Posted on May 27, 2013

Hyundai getz starting problem

My getz 1.5cdri dose not alwas start. two week ago it would not start for three days then just started. while it did not start had a dinostik run and had no problems. took copputer box out , tdc sencor and crank and cam sencors tested no problem. what could be wrong

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Champion:

An expert who has answered 200 questions.

  • Expert 241 Answers
  • Posted on May 27, 2013
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Champion:

An expert who has answered 200 questions.

Joined: Aug 22, 2011
Answers
241
Questions
0
Helped
110450
Points
760

Need to check the (starting system), battery, and the starter.
you may also need engine tune-up.

5 Related Answers

pal03246

Phil Lovisek

  • 726 Answers
  • Posted on Oct 02, 2008

SOURCE: 04 axima

Yes this could be caused by the Nissan NATS system. Your keys may need to be initilized for the car. Is the SECURITY light on steady, or is it flashing?? Check it. If its steady, than the NATS locked you out and you will not start the car. If its flashing, than NATS should be all set and the car should start. MAke sure, that you are using initilized keys.

Ad

Anonymous

  • 8 Answers
  • Posted on Jan 28, 2009

SOURCE: 94 jeep grand cherokee missing after it gets warm

YOU NEED TO HAVE IT SCANNED TO ISOLATE WHICH CYL. PROBALY AN INJECTOR OR CONNECTOR OR CRANK SENSOR LEAD RUBBING INTAKE

Anonymous

  • 4669 Answers
  • Posted on Feb 27, 2009

SOURCE: 1993 grand am no spark

You said you changed the ecm module, is that the ecm or the ignition module. Do you have access to a scanner to check cranking rpm? That way you can test the new crank sensor and the wiring and the ignition module.

Anonymous

  • 1 Answer
  • Posted on May 10, 2009

SOURCE: stopped while running

I had the same problem. I found out that the fuel pump was not putting out enough pressure. changed the pump and bam down the road I went.

Anonymous

  • 3600 Answers
  • Posted on Aug 19, 2009

SOURCE: 2000 chevy surburban 1500 will crank but no start. waited one day

replace fuel filter first then test fuel pump with a rented fuel pump tester regulator test pressure while running then pull hose on the fuel pressure regulator see if the pressure goes up if it does then it does not need replacing you will need to replace then fuel pump and fuel sock, and if you ran it lower than 1/4 tank you may have over heated the pump.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2006 Hyundai Getz. The car lost acceleration now won't start after fuel pump & filter replaced/

Question edited for clarity and full 'year make model'.
Question moved to correct category.

Did you disconnect the battery when you did that work. That would mean the security needs to be reset. They seem to have a history of not starting though!!

https://www.google.com/search?q=2006+hyundai+getz+immobilizer+reset

..
0helpful
1answer

Hyundai Getz 2008 model Engine TEMP. not indicating when hot.

Check temperature sensor,fans,thermostat, water pump.
1helpful
1answer

Hyundai getz starting problem

run the fault codes and find exactly which sensor should have been fitted
0helpful
1answer

HYUNDAI GETZ 1.3 2005 A/C NO SPARK NO FUEL

Some info about the car can be found
The Korean Car Guide Hyundai Getz Part II Engine


The failure to start could be due to the Crank Timing Sensor. The sensor not working will stop the computer from knowing when the spark should be activated and the injection of the fuel should take place.
I hope this is the problem. and that you can find
This is only my opinion and It seems to fit the problem posted
0helpful
1answer

Hyundai getz starting problem

Can i hot wire my hundai getz
1helpful
2answers

Getz 2007 46000km has like a tappet noise coming from motor car starts and runs well we have only had it 2 weeks and had been looking 4 3 months 4 a car was gonna buy a toyota corolla but chose 2 buy the...

drain the oil flush the engine then put in good grade of oil the tappet is sticking as hyundais have trouble getting oil round the engine this wont stop the problem but will make the noise go away until you can get the tappet replaced
Not finding what you are looking for?

2,173 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...