Trouble codes po758 p0758d

have vehicle scanned for trouble code

Hello. Your vehicle has a shift solenoid electrical circuit malfunction; that solenoid is not 'energizing' properly, causing rough to no shift conditions. Good luck and keep me informed; if you want to.

OBD II Trouble Codes Home

P0758 Chevrolet P0758 Chevrolet - 2-3 Shift Solenoid Circuit Electrical
Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty 2-3 Shift Solenoid Valve
- 2-3 Shift Solenoid Valve harness or connectors
- 2-3 Shift Solenoid Valve circuit is open or shorted
What does this mean? When is the code detected?
When the Powertrain Control Module (PCM) detects a continuous open, short to ground or short to power in the 2-3 Shift Solenoid (SS) valve circuit, then DTC P0758 sets.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Transmission will not shift gears
P0758 Chevrolet Description
The 2-3 Shift Solenoid (SS) valve controls the fluid flow acting on the 2-3 shift valves. The 2-3 SS valve is a normally-open exhaust valve that is used with the 1-2 SS valve in order to allow four different shifting combinations. The solenoid attaches to the control valve body within the transmission. The Powertrain Control Module (PCM) controls the solenoid by providing the ground path.

Read more: http://engine-codes.com/p0758_chevrolet.html#ixzz3kcwzXFmK

Shift solenoid B electrical, transmission .Any problem with shifting,any after market electrical[starter,alarm].

IT'S YOUR SHIFT SOLENOID LOCATED IN THE PAN UNDER FILTER WITH 2 WIRES GOING TO IT NEEDS REPLACED OR YOU WILL RUIN YOUR TRANSMISSION THE SOLENOID CODE IS PO755 YOUR PO700 IS WHAT MAKES YOUR LIGHT LUMINATE UNTIL PROBLEM IS RESOLVED

Check it out

All these code's are to your transmission, your mech needs to do more then pull code's, he needs to look at date on sensor to transmission before opening.

P0740 - Torque converter clutch solenoid circuit

P0758 - Shift solenoid (B) electrical

P0785 - Shift timing solenoid

P0761 - Shift solenoid (C) performance or stuck off

I would try Trans - X first pores right in to trans.

CODE PO758 IS A/T 2 - 3 SHIFT SOLENOID CIRCUIT 4T40 -E OR 4T45 -E CONDITIONS. THE 2 - 3 SHIFT SOLENOID IS DAMAGED OR HAS FAILED.OR CHECK THE ERLS FUSE.

Those codes are for the B shift solenoid you either have a faulty solenoid or wire issue to that solenoid,the pan will have to come down the solenoid checked and the wiring from the PCM to the trans checked.I have seen alot of wiring rubbed thru ontop of the bell housing on this model.