SOURCE: "check engine" icon is lit
First verify that battery is fully charged (>11volts), the throttle is closed, the transmission is in neutral, and all accessories like radio/fan/defog/etc. are off. The engine should be warm but not running with key off. Under the driver's seat there is a diagnostic connector box. Flip open the cover and on the inside of the cover you will see a chart of the terminals. Use a small jumper wire (or a paper clip) and connect the TE1 and E1 terminals together. Now turn ignition switch to on with key but do not start. Check engine light will now blink code(s), for example: three blinks followed by a pause and then two blinks is the code 32. Copy down the codes and check back here. The code(s) will repeat in order until you turn key off. Don't forget to remove the jumper wire before driving.
SOURCE: i need the timen mark
hey i have timing marks for 3ct 93 estima if you want them ill have to email you can email me at [email protected] there to big to upload on this site.
44 views
Usually answered in minutes!
×