Starter removal - 1994 Isuzu Trooper

The key lock cylinder operates the ignition switch sometimes ignition switch is separate sorry I didn't find where ignition switch is located if the lock cylinder is plugged into it.
You should have a starter relay and starter relay fuse.
This diagram of starter circuit shows the clutch pedal switch in the circuit on an automatic should have the neutral safety switch in the circuit. This is for 95 Rodeo.
Stater Motor Circuit Diagram (1995-1997 2.6L Isuzu Rodeo) (easyautodiagnostics.com)

How do I remove the key ignition cylinder? ' Isuzu SUV Forum (planetisuzoo.com)
Isuzu Trooper Ignition Switch Replacement ' Cost & Service ' RepairSmith
Changing the Ignition Lock: Changing the Ignition Lock, Safley ... (2carpros.com)
Starter and solenoid
Isuzu Trooper Starter replace under 1 Hour - YouTube
Isuzu Trooper (1995 - 1996) - fuse box diagram - Auto Genius
Starting System & Wiring Diagram - YouTube

Removing the front exhaust pipe from the engine will give you the necessary space to replace the starter motor on your Isuzu Trooper.
Click this link to get more details:---- http://technoanswers.blogspot.com/2011/02/how-to-replace-starter-on-1998-isuzu.html --------------------- This should help.Thanks.Helpmech.

follow your positive cable from battery ,the starter is at the other end its held to motor by two bolts i believe is a14mm or 15 mm

I recommend you get the Haynes repair manual on your vehicle. Start by removing the negative battery terminal, then removing the retaining bolts from the starter followed by removing the wires from the starter. Reverse the process to put the new starter on.

Remove the positive battery cable first.
The starter is on the passenger side of the engine. Might be easier to get to from below. Remove the bolts holding the wiring to it than the bolts that mount the starter in place.
Be careful if it has shims that you make sure you put them back in the same way. (These are little thin spacers that go between the mounting surface and the starter).
Installation is reverse. Probably would take you no more than 30 minutes to do it all.

Unscrew and disconect the wires. Unscrew and remove the 2-17mm bolt's. Their is a small stud which holds the starter in place leave it to last unscrew it and thats it.

I can hook you up!! lol Go to the autozone website at autozone.com and register your vehicle. It's free and you will have access to an online repair manual for your vehicle. The step by step instructions for removing the starter on your vehicle is there. ( I checked). Hope this helped and best wishes.

May be stuck on dial pins.

I just had to replace the starter on mine and you have to cut the exhaust pipe off to remove the starter. Take the 3 nuts off where the exhaust is attached to the manifold then using a sawzall I cut it in the straight section after the bend so it could sleeved and welded back with ease, once the pipe is out of the way the starter will just about fall out. Bad design by Isuzu. Perhaps some sort of pay back if you know what I mean.

you must remove engine mount on V6 engines