Free honda radio unlock code

Most honda's radios had a theft deterent system that requires a 4 digit code to be entered after power to the system is lost. If you do not have a code setup, look in your owners manual, some had a factory set code to unlock and allow you to set your own code. If not, you may need to see a dealer as they would be the only ones I know that would have the capability to unlock it.

1. • 1 Look in your owner's manual booklet for your radio anti-theft code. The code is printed on a small card (similar to a credit card) and included with your owner's manual. If you can find the code, skip to Step 5.
     If you cannot find the code, you'll need to retrieve it.
     
   • 2 Turn your ignition off to begin retrieving your radio code. Press and hold the "1" and "6" preset buttons on your radio. Turn your ignition on.
     
   • 3 Write down the code displayed on your radio. The display will flash with two numbers: one beginning with a "U" and one beginning with a "L." Write down both numbers (beginning with the "U" number), and then disregard the "U" and the "L."
     This number (eight digits) is your radio serial code. You'll need it to retrieve your radio anti-theft code.
     
   • 4 Contact Honda to retrieve your radio anti-theft code. You'll need your 17-digit Vehicle Identification Number, found beneath the driver's side of the windshield and your radio serial code. Honda's customer service number is (800) 999-1009. Provide the representative with the information to acquire your radio anti-theft code.
     You can also retrieve your radio anti-theft code online for free at https://radio-navicode.honda.com/
     
   • 5 Turn your ignition to "Acc" or "On" to power on your radio. Enter your radio anti-theft code using the preset buttons at the bottom of your radio. For example, if your anti-theft code is "55512," you would press the "5" button three times, then the "1" button, then the "2" button. This will unlock and reset your Honda radio.
     

if you get to step 4 email the code to me at [email protected]


Service Information

1999 Chevrolet Chevy K Pickup - 4WD ' Escalade, Pickup Classic, Suburban, Tahoe, Yukon VIN C/K Service Manual ' Document ID: 522597 Radio Displays LOC, LOCKED, or CODE Step
Action
Value(s)
Yes
No
1

1. Turn the ignition off.
2. Disconnect the negative battery cable for 1 minute.
3. Reconnect the battery cable.
4. Turn the ignition to run.
5. Turn the radio on.

Does radio now operate?
--
--
Go to Step 2
2
Important: It will say Theftlock® on the face of the radio.
Does the Radio have Theftlock?
--
Go to Step 3
--
3
Is it possible to get the security code from the customer?
--
Go to Radio/Audio System Operation
Go to Step 4
4

1. Turn the ignition on.
2. Turn the radio off.
3. Depress and hold Pre-set buttons 2 and 3.
4. Write down the first three digits that appear on the radio display.
5. Depress AM/FM, write down the second three digits that appear on the radio display.

Did you receive the 6 digit Radio Display Code?
--
Go to Step 5
Send Radio in for repair
5
Contact Delco Assistance to obtain a "Radio Back-up Code".
--
Go to Step 6
--
6

1. Use the hours and minutes buttons on the radio and install the 4 digit "Radio Back-up Code".
2. Depress the AM/FM button.
"SEC" should display.

Did the radio unlock?
--
Go to Step 7
Repeat Step 6
7
Important: This will remove the original owner's code. The owner will then be able to reinstall their own personal security code.
Step 6 only unlocked the radio, if the original code is not known, repeat step 6.
Did the radio display?
--
--
Repeat Step 7

yes call the dealer and explain to the service department what you did and tell them you need the unlock code for your radio. they should do this for free.

See hear :
http://car-radio-unlock.blogspot.com
car audio,audio car systems,car radio,unlock radio,radio code,code forradio,car radio codes,free radio code,codes for radio,radio unlock code

*** Please click the "Was this helpful" Yes thumbs up! ***

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ingnition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ingition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6 buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

-----------------------------------------------------------------------------------
So what happened to begin with?
See also: http://automobiles.honda.com/information/frequently-asked-questions.aspx?Question=2

If the power from your battery to the Honda radio is interrupted the Anti-Theft feature kicks in, the radio is rendered inoperable and the screen reads 'CODE'. You must enter in the Anti-Theft Radio Unlock Code (usually 5 digits) to make it operational again. You know that much by now.

What you have is the SERIAL NUMBER. Your almost there!!! The hard part is over! Go to the bottom below for the website option or phone number option you need to get the unlock code!!!

*** Please click the "Was this helpful? Yes" (thumbs up)! ***

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ingnition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ingition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6 buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

-----------------------------------------------------------------------------------
So what happened to begin with?
See also: http://automobiles.honda.com/information/frequently-asked-questions.aspx?Question=2

If the power from your battery to the Honda radio is interrupted the Anti-Theft feature kicks in, the radio is rendered inoperable and the screen reads 'CODE'. You must enter in the Anti-Theft Radio Unlock Code (usually 5 digits) to make it operational again. You know that much by now.

Don't post your s/n & vin online!!

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ingnition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ingition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6 buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

-----------------------------------------------------------------------------------
So what happened to begin with?
See also: http://automobiles.honda.com/information/frequently-asked-questions.aspx?Question=2

If the power from your battery to the Honda radio is interrupted the Anti-Theft feature kicks in, the radio is rendered inoperable and the screen reads 'CODE'. You must enter in the Anti-Theft Radio Unlock Code (usually 5 digits) to make it operational again. You know that much by now.

You only get like 10 tries this means you made to many attempts trying to put the wrong code in. Disconnect the battery cable and then try putting the code in the radio again.

I had the same issue with the radio code error lock on a 2005 CRV. I was unaware of the code procedure and had locked the radio in the "ERROR E" mode. I was able to unlock the radio by pulling the #9 back up fuse located in the fuse box in the engine compartment. This reset the radio to CODE which then allowed me to input the 5 digit number which I had in my glove box along with my owner's manual. I am happy to report I now have a working radio/ CD player.