My Jeep will just turn off when you're driving. Feels like it is going to down shift and then nothing. Then it won't start for a bit. After ahwhile it'll turn back on. Just now I can't get it to start. Replaced coil last night. Any ideas? I read about a Crankshaft Position Sensor in another post, do Jeep Cherokee's have these as well? Thanks
SOURCE: 96 jeep grand cherokee laredo stalling
Quite possible you have a bad ignition coil. As coil heats up it breaks down and will not return to normal till it cools down. Check for spark the next time this happens. If spark is weak or not there, it warrants testing or replacement.
SOURCE: 1993 Jeep Grand Cherokee not getting power to coil
I don't work on Jeeps, but the Rangers have a power relay for the ignition. You might want to try asking at Autozone or O'reillys if the Jeep has any relays. It might be worthwhile to check the fuse panel to see if something blew that might control 2 or 3 things including the ignition. Hope this helps you.
SOURCE: No fire to coil from coil on 96 model Jeep Grand Cherokee.
You need to put the harmonic balance for the 96 jeep on this motor,then put the crankshaft sensor on for the 96 jeep on the vehicle,this should fix you up.The crankshaft sensor and the harmonic balance have to go together.If I can be further help,let me know.>>[email protected]
Testimonial: "Roniecon was extremely helpful trying to solve this problem, he hung in there to the very end. He spent a lot of time researching the problem. THANKS"
SOURCE: My 1996 Jeep Grand Cherokee cuts off while driving
try the map sensor it controls the air flow thru the engine.
SOURCE: where is the crankshaft position
The Crankshaft Position Sensor (CKP) is mounted to the transmission bellhousing at the left/rear side of the engine block...
Inatallation: 4.0L Engine
New replacement sensors will be equipped with a
paper spacer glued to bottom of sensor. If installing (returning) a
used sensor to vehicle, a new paper spacer must be installed to bottom
of sensor. This spacer will be ground off the first time engine is
started. If spacer is not used, sensor will be broken the first time
engine is started.
New Sensors:
Be sure paper spacer is installed to bottom of sensor. If not, obtain spacer PN05252229.
Used Sensors:
Clean bottom of sensor and install spacer PN05252229.
Hope helps (remember to rate and comment this free answer).
104 views
Usually answered in minutes!
×