Remove one Phillips screw from leading edge of door panel (near latch).
Remove small cap behind the door handle, inside another Phillips screw -
remove screw and then the cup behind the handle. Look down in arm rest
and there is another Phillips screw. Last screw is behind the
approximately 1 1/2 inch plug on front upper corner of panel. At this
point, gently pry around lower edge and sides - there are either five or
six clips pressed into the door frame. Once all are disengaged, gently
swing the bottom of the panel out and lift off the top edge of door next
to window opening. Once panel is off door, gently remove the control
plug from the door lock/window control on the rear of panel. Install in
reverse order
hope this helps
381 views
Usually answered in minutes!
×