Brake Lights Problems

This sounds that your car is either need reset,or something wrong with the wiring system. It is better to get from an expert Electrician advise and help.

I have a 2004 Sorento EX and my EXT fuse along with the stop lamp fuse kept blowing. The ext would blow as soon as I turned the vehicle on. The stop lamp would blow after a couple pushes of the brake pedal causeing me to have no rear lights at all regarding brake and the lights that you turn on at night. After much reading online in forums such as this, I was led on a chase looking for grounding wires, broken wires, dirty battery terminals, faulty altinator, and for a drl module. I could not find a drl module as I now do not believe there is one in sorentos, or at least in mine. I then came to the brake switch that is located on the arm of the brake pedal. I disconnected it, put a couple of new fuses in, started my vehicle and checked my fuses, and at last they did not blow! I reconnected the brake switch and checked the fuses and they had blown. I have a hunch that I am dealing with a faulty brake switch. Hope this helps

Turn signal are not meant to stay on. Brake lights only come on when you press the brake pedal.Then you have tail lights that are totally different from brake and signals light.they are for night use.

well when the brake light's stop working it's because the stop light switch went bad it's right under the brake pedal.

A belt wouldn't cause all those lights to come on, If you were driving through a lot of water like you stated, it might have shorted out the Body Control Module, would recommend taking to a repair shop or the dealer to have this repaired. Hope this helps

brake light switch malfunction.check on pedal

it sounds like a lot of seperate problems with the abs light just check to make sure there is plenty of brake fluid in the resovior what causes the metal to metal noise ??

The problem usually lies in the wiring harness.

Could br the light switch is bad.

brake light switch or a headlight switch