Maintenance Required light on after dead battery

1. Hold reset button down while turning ignition on.
2. Keep depressed until display is reset.

you should be able to reset the light by using a code reader.

unhook the battery for at least 60 seconds. if it comes back on you need to read codes and fix problem. go to a parts store and they will scan codes for free

Welcome to FIxYa.com

Oil Change light:

To reset the "CHANGE OIL" light, turn the ignition switch to the run position with the engine off. Fully depress and release the accelerator pedal three times within 5 seconds. The light will flash twice and go out.

Maintenance warning light? MIL? Check engine? Maintenance Required?

You will have to go to Auto Zone to have the code read and then fix the code problem and then clear code with code reader

Regards, Lee Davidian

Thank you for using FixYa.com

The maintenance required light does not indicate any problem with the engine or systems like a Check Engine Light (CEL) does. This light is normally a reminder to change the oil. Getting the light to turn off is really easy.

In order, follow these steps:

1. Press and hold down the trip odometer reset button.
2. Turn the key to the on position without starting the engine.
3. Continue to hold down the reset button; The light should go out within 10-15 seconds.

God bless and good luck.

When "SERVICE REMINDER" appears on the Electronic Vehicle Information Center, press the "INFO" button and press the "SET" button within 5 seconds.

Hope this help (remember comment and rated this).

Your dodge is an OBD1 compliant vehicle. All you need to do to retrieve the code for what caused the light to illuminate is cycle your ignition key ON-OFF-ON-OFF-ON within a 5 second period. The light will illuminate "x" amount of times, pause, and then illuminate "x" amount of times. For example, if it illuminates 2 times then pauses then illuminates 4 times, it is a code 24. There are many different reasons the light will come on, so after you find the code ask another question regarding the code number and what it means.

If I remember correctly, on the dash you have a select button. Hold the button down then turn the key on, until the maintenance light blinks and goes out. Turn the key off then back on and your light should be out.

The dealer has issued a technical service bulletin regarding the maintinace required lamp I belive it states all lights headlamps tail and side markers have to be off and the door must be closed in order for the reset to work. How to Reset
Press and hold the trip/reset button, turn the ignition switch ON , and continue to hold the button for more than 10 seconds. this should fix the problem if not the the daytime running lights will have to be disabled before it will reset.

I have the same problem and I read in the user manual that it flashes as a reminder to get oil changed. Depending on how many miles between changes it flashes different amount of times. Manual tells how to reset the gauge. Might be more than that but check your book first.