I lost my keys to my 96 dodge dakota so i tried to forcefully use a screwdriver to start it resulting in a busted ignition i can get it to turn to the point of starting but the starter isnt turning over how do i bypass my ignition all together?

Usually you need to put the key in and turn a little(into the accessory poistion) then use a nail or small screwdriver to push up on the pin under the key cylinder. I had to replace the key on my 2002 Jeep and that was the steps.

You will just do more damage to the truck. Go to a dodge dealer, they can make you a key from vehicle ID number.

the lock(key part) is broke..the finger ion the back is maybe gone entirely..(mine broke and the entire key assembly flew out across my seat..I have been starting my car with a flatblade screwdriver ever since..nearly 2 years now)..try to push it in towards the steering colum.. other wise you may nned to replace the key assembly ..

Switch is gone bad. Replace.

Yes this may help try a new ignition switch .i had a 93 and it done the same thing to me .hope this help you ....

Sounds more like the lock and cylinder issue.

I have a 93 dodge dakota pick up. When I turn the key I get nothing, The radio and the lights work fine. I had starter checked and the battery changed, It will run if you push it to start but not with the key.

a bad crank sensor or dist pickup plate can cause this.... check the fuses in the fuse block under the hood for any blown ..... a bad auto shut down relay may cause it .....try putting a test light on the green and orange wire and see if it lights up when you try to crank it

I would start with the Starter check for voltage getting to the starter should read 12 volts at both terminals

I have a '99 dodge dakota, 4 cyl, 5 speed manual. While researching a no start problem ran across possible solution to this problem. If no guage lights show when key truned to on position then normally a bad ignition switch. With fully charged battery and working ignition switch guage lights should slight up then go out when ignition in "on" position. Try shaking the key back and forth.


Dave