Front end / wheel vibration under acceleration, becomes worse at 50-65 + MPH stops when off the gas / coasting or going down hill. New upper ball joints and wheel alignment. Is it motor mounts or something else? CV boots on drive shafts are intact and not leaking 175,000 mile auto trans 4 cylinder motor.
SOURCE: 2001 CR-V drive line judder
if you drive when you apply gas if you have vibration the u joint are loose or jam i change does drive shaft often they dont sell parts to repair in canada its 752.00 plus labour hope it help you fixya our post thanks pierre
SOURCE: Front end vibration, tires new, alignment, half
Check for play in the steering rack and tie rod ends.
Testimonial: "Thanks, I'll look into that next"
SOURCE: cv joint boot missing and vibration at highway speeds
Replacing the boot is not even an option at this point. Get yourself a chiltons or haynes manual for instructions and I recommend replacing the entire axle (prices are very reasonable as rebuilt or from a scrapyard). I recommend buying the manual first and reading it over, then deciding if the job is too difficult and if you need to have it done at a shop. The manual will help you in many situations so buying one will save you $ in the long run, even if you have this job done elsewhere!!!
SOURCE: 2002 honda civic ex front end vibrates and knocks at 60 mph
did you do a wheel alignment after replacing these parts also some cv jints need to be greased. also check the wheel balance
342 views
Usually answered in minutes!
×