Where is the fuse box located in cadillac 2001 eldorado

SOURCE: where is the fuse box

On the 96, so far I've found two locations for fuse boxes. The first is on the drivers side in the engine compartment behind the air filter housing. there is a plastic shield.

The other place is a PITA to get to. Get into the truck and remove the cloth lining from the back of the seats. It's on the passengers side. To remove this cloth, there are four or five bolts on the underneight side of the trunk deck (get in the trunk, look up).

I think there is one more place inside, but I can't find it. It might be under the dash or in one of the kick panels. Still looking for it. Crazy ole GM.

SOURCE: O2 Sensor on a 1996 Cadillac Eldorado

Hello mrsalbert, my name is JShreader. Thank you for choosing fixya.com

Depending on which oxygen sensor you are looking for...there are several of them throughout the Exhaust System. I will start out by giving you a brief description of what and oxygen sensor is, and they're general purpose.

DESCRIPTION
Four Heated Oxygen Sensors (HO2S) are mounted in the exhaust system where they monitor the oxygen content in the exhaust stream. There is an oxygen sensor mounted in each exhaust manifold and one on each end of the catalytic converter. the oxygen sensor located in the front exhaust manifold is the Bank 2 Sensor 1 (Front) sensor. The oxygen sensor located in the rear exhaust manifold is the Bank 1 Sensor 1 (Rear) sensor. The oxygen sensor located in the Y-pipe ahead of the catalytic converter is the Bank 1 Sensor 2 (Pre-converter) sensor. The oxygen sensor located in the catalytic converter outlet is the Bank 1 Sensor 3 (Post-converter) sensor.

OPERATION
An oxygen sensor acts like a battery because it creates its own signal voltage once it reaches operating temperature. This voltage is produced when the oxygen content in the exhaust stream is different than the oxygen content in the atmosphere. A lean condition (high oxygen content in exhaust) will produce a low voltage (near 0 volts) and a rich condition (low oxygen content in exhaust) will produce a high voltage (near one volt). The PCM provides a reference signal voltage (0.45 volt) and a ground to the sensor. The PCM reference voltage is necessary because the oxygen sensors do not provide their own voltage until they reach operating temperature.

HEATING ELEMENT
the oxygen sensors also incorporate a heating element inside of the sensor housing. This heating element is energized with the ignition On and allows the sensors to reach operating temperatures quickly. The PCM can then use oxygen sensor information sooner after engine start-up.

PCM INPUTS
The PCM uses oxygen sensor information during Closed Loop operation to constantly adjust fuel control to reduce exhaust emissions. Because the oxygen sensors provide information sooner after engine start-up, exhaust emissions are reduced. Faulty oxygen sensors will cause various driveability conditions and will set a DTC.

That being said...I uploaded a .pdf for you of pictures showing the locations of ALL the oxygen Sensors on your Vehicle. You can download it by clicking HERE.

I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

SOURCE: 99 eldorado fuse box location please

there are two of them by the looks of it. one on the left front of engine compartment and the other is in the trunk. here are a couple pictures, hope this helps.

Testimonial: "this helps me tremendously. thank you so much! the pics were very helpful."

Mark Carrington

• 192 Answers
• Posted on May 23, 2010

SOURCE: how to read codes for 2001 Eldorado Cadillac

Take a look at your air con controls on the centre console.

You will see an "OFF" button and to the right of this you will see a toggle switch with an up arrow with the word "PASS" just below it.

Simultaneously press the "OFF" button and the up arrow together for three seconds or so and release when you see the instrument cluster lights come on.
You are now in diagnostic mode.
Read the codes from the digital display on the instrument cluster.
Have a pen and note pad ready to write down the codes.

Marvin

• 85242 Answers
• Posted on Jun 12, 2010

SOURCE: where is 98 eldorado cadillac 4.6 starter located?

It is located in the valley between the cylinders. You can loosen the throtle body, all the bolts holding the intake manifold and then lift the manifols just enough without disturbing the fuel rail to gain access from the lest side of the car to the right. This can be done with common tools and the gaskets on the manifold and TB can be reused if not damaged.