I replace the throttle position sensor and still the car idles high and cut off when put in gear.
SOURCE: Where is the throttle position sensor on a
Lightning bolt on dash starts blinking and the freakin truck shuts off on the highway in the center lane. Real nice Dodge. Nice way to kill someone. Any body have aclue what happens to the fbw.
SOURCE: location of speed sensor for a 2003 dodge durango
the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only
SOURCE: Wife's durango is idling rough and running rough
With both codes pointing at TP sensor, I'd certainly take the time to replace it, as well as make sure connections to it are clean, and good. Chances are, you won't be able to take part back anyway. As far as exhaust goes, if it's leaking in the right places in may cause improper readings at sensors downstream, but if not obvious leak, I wouldn't be concentrating in that area right now.
SOURCE: Car idles
If it revs up and down you need retrain the car to idle. I know it sounds crazy but you need to ask dealer or local shop the steps to do it.
SOURCE: how do i replace cam positioning sensor in 2003 4.7 dodge durago
Answer
picREMOVAL - 4.7L
The Camshaft Position Sensor (CMP) on the 4.7L V–8 engine is bolted to the front/top of the right cylinder head (CMP Location—4.7L Engine).
It is easier to remove/install sensor from under vehicle.
Raise and support vehicle.
Disconnect electrical connector at CMP sensor (CMP Location—4.7L Engine).
Remove sensor mounting bolt (CMP Location—4.7L Engine).
Carefully twist sensor from cylinder head.
Check condition of sensor o-ring.
285 views
Usually answered in minutes!
×