2005 Nissan Altima Logo
Anonymous Posted on Apr 10, 2013

My brake lights dont work for a 2005 nissan altima. how many fuse boxes are there to check

My rear signal light work but the brake lights dont work. I check the fuse box on the passenger side under the hood. I check the fuse box inside the car by on the driving side. I turned the power switch so i wanted to know if there was another fuse box that i havent checked? or what should i do.

  • Anonymous Apr 12, 2013

    how do i know if i need to replace the Switch button? Do i just replace it to see if it works?

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jul 02, 2013
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jul 02, 2013
Answers
1
Questions
0
Helped
3014
Points
1

Does high stop lamp work?

5 Related Answers

clifford224

Clifford Beard

  • 1975 Answers
  • Posted on Jul 27, 2011

SOURCE: I have a 2006 Nissan Altima and my air conditioner

I would check the number 33 fuse (see diagram below). It could also be the relay for the compressor as well. Also there is a refridgerant pressure sensor and if that is faulty it will give the wrong readings to the computer which in turn will not give the correct voltage to the relay which would make it to where the relay would engage the compressor clutch. Below are some pictures of wiring diagrams as well as locations of the relay and the sensor. If you are in need of any other information that you think may help you or you need bigger pictures as I can only post up to a certain size here, feel free to email me at [email protected] and I will be happy to answer what I can.


clifford224_1015.gif

clifford224_1016.gif

clifford224_1017.gif

Ad

Anonymous

  • 651 Answers
  • Posted on Dec 01, 2008

SOURCE: Non working brake lights in Nissan Altima

make sure the button is working, it may need to be replaced. with your foot off the brake peddle, it is on upper part of brake peddle arm. when you let off brake peddle it pushes button in to shut lights off. it may just be stuck in, spray a little lubracant on it if it's stuck and push in manually several times to loosen.

Anonymous

  • 962 Answers
  • Posted on Apr 08, 2009

SOURCE: fuse box cover is missing

Check ALL the fuses for any burned out ones. With the fuse remover clip or needle nose pliars they can easily be removed. Unless you buy a diagram online or at a store. that;s the way to go.

Anonymous

  • 57 Answers
  • Posted on Aug 14, 2009

SOURCE: i need a fuse box diagram for a 2000 nissan

cheak the fuse

Anonymous

  • 396 Answers
  • Posted on Oct 28, 2009

SOURCE: ABS light with brake light come on and rear brakes

i have had the same problem whhat i did was take off the wheels cleaned everything with break cleaner then ssprayed some in the brake cilinder and has worked fine for me

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

My brake lights dont work for a 2005 nissan altima. how many fuse boxes are there to check

I saw two fuse boxes, one appears to be close to battery and interior fuse box.
As far as the interior fuse box, I'd look along lower edge of dash. Sometimes the fuse is located on the end of dash, have to open door to see it.
Do you want a wiring diagram for brake lites?
passenger compartment-ctwg0jt0l31spi5mbxkjzfop-3-0.jpg
0helpful
1answer

2000 altima passenger side rear lights (brake/signal/tail) not working. Replaced bulbs, fuses are good.

check whether the connectors on the rear light is not well connected.Also check the wiring whether are having sending power by using a tester as well.
0helpful
1answer

How do you replace the brake light on a Nissan Altima 2005

Rear Turn Signal, Brake and Parking Lights Removal and Installation To Remove:
  1. Remove or disconnect the following:
    • Trunk trim as needed
    • Nuts securing rear combination lamp assembly, from inside the trunk
    • Connectors
    • Combination lamp assembly
To Install:
  1. Install or connect the following:
    • Combination lamp assembly and connectors
    • Nuts securing combination lamp assembly
      1. Torque to: 22-33 in. lbs. (2.5-3.7 Nm)
  2. Replace trunk trim.
1helpful
1answer

My 2005 nissan altima has both tail lights out, the break lights work and i searched all over for the tail light fuse, but i cannot seem to find it. help?.

if its like most nissan s you have to remove the glovebox and the fuse box is behind it, the main box can also be located beside your battery, if both tail light blow it will, blow a fuse, so check your lights regular to save you the hassle of looking for fuses.
0helpful
1answer

2005 nissan altima HELP

SOUND LIKE THE BRAKE LIGHT SWITCH IS BAD.
0helpful
1answer

Parking lights

there is a relay for the taillights in the underhood power distribution box. if you haven't replaced it yet you can try that and see what happens. hope that helps
0helpful
1answer

Fuse box cover is missing

Check ALL the fuses for any burned out ones. With the fuse remover clip or needle nose pliars they can easily be removed. Unless you buy a diagram online or at a store. that;s the way to go.
Not finding what you are looking for?

3,024 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...