I have a 93 camry 4 cylinder 5 speed that would not start one very cold morning.
It still would not start when it warmed up. Traced problem to no power at fuel pump connector. The fuel pump runs when power is applied directly.
Where are the relays, safety switch, fusible links, etc?
The info you need will be in here
http://www.turboninjas.com/camry/
Post a comment if the link does not work. I have a local copy.
Check you're fuse, could be blown.
If you want to solve your problem, click on the link I attached 1993 Toyota Camry 200SE Workshop Service Repair Manual
SOURCE: How to remove ignition cylinder from Toyota Camry 1993
Here are step-by-step instructions for the removal and re-installation of your ignition cylinder on your Toyota. Hope this sheds some light on the subject and solves your problem. Have a great day!
CAUTIONSome
models covered by this guidemay be equipped with a Supplemental
Restraint System (SRS), which uses an air bag. Whenever working near
any of the SRS components, such as the impact sensors, the air bag
module, steering column and instrument panel, disable the SRS, as
described in .
On some vehicles, it may be necessary to remove the steering wheel and combination switch first.
To install:
SOURCE: 1995 camry has no ignition fire
I think for sure that the timing belt has jumped a tooth. This can happen if your water pump, or your idler pulley, which are driven by the timing belt, "locks up" for a second. Best advice: replace the timing belt (you should not "reuse" it, as once it slips a tooth, that tooth is now weakend. Also, check the feel of the water pump impeller-gear...if it feels gritty or does not spin freely, replace the water pump while you are in there. It's not much more work. Also check the IDLER pulley for the same feel. If it feels bad/does not spin free, replace it. One or the other caused your problem.
Let me know how it turen out.
SOURCE: location of fuel filter on 2004 camry le 4 cylinder
ITS LOCATED ON THE FIREWALL IN THE CENTER
547 views
Usually answered in minutes!
×