My right turning signal sometimes doesnt work. The light in the dash stays on, but doesnt flash. When this happens the front light stays on when the signal is applied, but the back one doent work. Ive replaced the bulb, but the problem still persists. It might be a bad ground, but I dont how to fix it.

was the correct bulb used? this sounds like a single function bulb was used NOT the bulb that will light with the headlights and ALso produce turn singles

I would change out the turn signal bulb on the right front. A blown bulb can cause the fast flash issue. The signals staying on is not related to the bulb being blown. That is most likely a problem with the multifunction switch, the knob you use to signal.

Check your bulbs. Almost always your description means a bulb is burned out. Check for good grounds.

change the bulb if still out then check and test socket/ground wiring/wire harness for damage

Sounds like a ground problem to me. Bulbs are not getting there ground to complete the circuit so they backfed through the other bulbs.

could just be a faulty relay, if you have not had a problem before i would think it was the relay.

Hello Kellie.

Usually when this happens a filament in a bulb has broken and crossed over to the signal light circuit feeding it from the park light circuit.
Check the bulbs in the rear right and front right.
You might as well replace all while you have them out, they are not expensive.
They take a #1157 bulb.
If you need more assistance with this ask me here.

Thank you for using FixYa.

KL

It could be your flasher relay going out. Should be under the dash.

check grounded electrical wiring.