Just installed new clutch. car wont start?

SOURCE: just had clutch replaced on 2003 hyundi tiburon 2.0 now car wont start it turns over sounds like it wants to start but wont and it started fine b fot clutch was replaced comp said to change crankshaft

If the problem is related to the clutch replacement, there is most likely an electrical connector that did not get plugged back in or a ground connector that did not get put back where it came from. I would also suspect wires getting pinched between the transmission bell housing and the engine block.

The best thing to do would be to scan the engine control module for fault codes. This could lead you to the problem which may, or may not, have anything to do with the clutch replacement.

SOURCE: car is trying to start but wont turn over. spark

Im proberly no help as diff car, but we had same problem .it went for like 2000kms, and it ended up being a blocked thermostat which upset a senor,, and when it heated it died, we flushed out the cooling system and disconnected the battery for a few minutes and away it went