2000 mercedez E 430 spilled water in center console and car wouldn't start or go into reverse. Blew dry for about 10 minutes then car started but still wouldn't go into reverse. called an 800 number and they had us take a pen and reset something and then it went into reverse but now in park or drive the reverse lights are constantly on
SOURCE: My 2001 Kia sephia won't start.The lights and
tap on starter with hammer if starts replace starter
Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- The engine may stumble or stallPossible causes- Ignition/Distributor engine speed sensor harness circuit is open or shorted
- Ignition/Distributor engine speed sensor poor electrical connection
- Faulty Ignition/Distributor engine speed sensor
- Faulty Crankshaft Position sensor
- Low battery charge
- Faulty Engine Control Module (ECM)When is the code detected?The P0322 code is triggered when the Engine Control Module (ECM) detects no signal.P0322 VOLKSWAGEN DescriptionIgnition failure sensor is used to check whether the spark ignition is occurred correctly or not and also used to tachometer drive. The sensor monitors the voltage difference between a resistance which is on the battery circuit for ignition coil. When the ignition coil works properly, the electric current through the resistance is detected as voltage drop. This is confirmed for every ignition event with the crankshaft sensor and the camshaft sensor. If ECM detects a malfunction, no ignition is possible, so the engine would not start. If there is no ignition signal for a predetermined cycle for one or two ignition coils, an ignition coil circuit failure exists.
79 views
Usually answered in minutes!
×