Have you tried to manually reset this.
Start vehicle
Press and hold the odometer button in (button in speedo) intil service into lights up
Toggle through using switch on indicator stalk
press button on item to reset
and the again to confirm
SOURCE: BMW 318i Service Light
BMW SERVICE RESET Take a small wire, paperclip, or elect wire and bend like a horseshoe. No light or equipment necessary Open the diagnostic data port, the one were the little pacman centre is located. Turn the ignition to position 2, don?t start. Connect pin7 always first and then pin 19. Hold for 4 seconds. Remove wire and settings will be reset. Warning if you hold the wire longer than 10 seconds you may reset inspection intervals 1 and 2. I?ve done this twice and it definitely work on my E36
SOURCE: How do you reset the Service light on 2006 BMW 325
Hi , to reset the service light you will need to insert the key and turn the ignition lights on but do not start the engine. you will see a push button on the lower left side of the instrument panel press and hold this until you have a triangle appear which then turns to the brake warning symbol , release the push button then press and hold the bc button in the indicator arm until reset appears , release and again press and hold the bc button until you have a moving clock symbol appear , release the bc button and wait for the display to change , once this has reset turn off the ignition and the service symbol should have reset . you may want to print these instructions before resetting , regards Mark.
SOURCE: how to reset service light for BMW e90 320i in
This is for 2001 onwards :
- Iginition OFF (POS 0) with key in.
- Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
- Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display
- *Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
- Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
- While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.
Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
You can find more information at:
http://www.bmwtips.com/tipsntricks/reset-plug/reset.htm
SOURCE: hi; my bmw 320i e90
The smoke is blue, correct?
When you changed the oil separator, did you clean out the hose that goes from the valve cover to the oil separator?
The next suspect for smoking at idle would be the intake valve seals, but that would be the first time that I ever heard of a problem there.
SOURCE: My bmw 320i e90 2005 only cranks but won't start
Car not starting or turning over indicates towards multiple possibilities.
It can be issue with battery or weak battery. But if battery checks out ok, then
it can be starter issue or faulty alternator or problem with low fuel pressure
or no spark at spark plugs due to dirty spark plugs or faulty
ignition coil or injectors getting cracked or dirty and needs to be cleaned. To confirm the problem, the basic troubleshooting is required. Click this link below and follow the troubleshooting:------ http://technoanswers.blogspot.in/2012/02/car-starting-issues.html --------- This will help.
Thanks.
1,134 views
Usually answered in minutes!
×