Helped a lot of people get unlock codes, but now have a problem getting radio to accept or display the needed radio code numbers to give GM's auto phone system to obtain unlock code for this radio. Unable to get past first step. Hold presets #2 & #3 for 10 seconds to get first 3 numbers of radio code. DIsplay still shows clock and LOCK.
SOURCE: Radio lock
GM DELCO THEFTLOCK RADIO UNLOCK CODE:
1. Press and hold presets 2 and 3 for about 5 to 10 seconds until you
get 3 digits on your display. This is the first 3 of 6 digits you will
need, so write 'em down.
2. After doing step one and writing down the code, immediately press
the
AM/FM button to get the last 3 of the 6 numbers you'll need, and write
'em down. (if you wait too long between steps 1 and 2 and the LOC code
displays again, just start over).
3. Call this number, it's a prerecorded message, so don't worry about
having to talk to anyone...1-800-537-5140. The voice will ask if
you're
calling for Chevy, Pontiac, Cadillac, etc... When you here him tell
you
to press "2" for Pontiac, press 206010 and hit the # key. He'll ask
you
for the 6 digit code that you've written down. Enter that and press
the
* key. He will then give you a code, and the option to get additional
4
digit codes, but one should be sufficient.
4. Follow the normal procedure in your owners manual for unlocking the
radio with your new code...press the hour set button on your radio
until
you get the first two numbers of the code, then press the minute set
button until you've entered the last two numbers. Immediately press
the
AM/FM button once the correct code is entered and the code SEC or
"secured" will be displayed on the display screen. Now, just turn the
radio on, and your ready to roll.
There is an additional step you can take to remove all codes from the
radio and start from scratch by entering your own personalized 4 digit
code so that it won't get you in a pickle again! Just repeat step 4
and
you should get a display screen that reads ---. This means the code is
out, and you can now program your own code. Of course, once you
receive
the 4 digit code from the GM recorded message, just keep it in a safe
place, because you can use that same code again and again should you
have any more problems with it in the future. Good luck, and yes, it
does work.
SOURCE: unlocking my radio, 2005 pathfinder
As far as I know there is no code on a Nissan factory radio. Check the fuses for the radio.
SOURCE: Factory Gm RDS radio
call the dealer for the reset code the theft system for the radio has been turned on
SOURCE: BMW Z3 WRONG UNLOCK RADIO CODE HOW TO GET THE RIGHT ONE
If the radio is displaying code wait, or wait, then the ignition and radio must remain on for 1hour. I would contact a dealer within the USA and provide them with your radio serial number. The serial number can be displayed in the radio by pressing and holding down the "M" button while turning on the ignition.
SOURCE: radio unlock coed for chevy impala
• A module which communicates on the class 2 serial data circuit which supplies VIN information to the radio is replaced and not properly setup with the correct VIN information for that vehicle. The only way to unlock the radio is by using a scan tool.
466 views
Usually answered in minutes!
×