After replacing the ignation immobilizer,the car cannot start and computer says coil is open/short
Did you reset the computer. Usually disconnecting the battery for about 10 minutes should do it. If this does not fix it, you need to recheck your work. Something you did has caused the message. Did you short circut a wire, burn a fuse, forget to reconnect something? The immobilizer probably works by immobilization of the vehicle's coil circut. Thus, causing the computer message to display about the coil issue. Try reset computer of vehicle should work.
SOURCE: 1992 pontiac will not start
If the sparck fire has no fire, then check the coil module plug and clean with dust remover, then plug again and check if ther any fire from the coil conectors.
The point is if no fire never will come up, you will need to check this point to have fire.
SOURCE: replace ignation module and coils car runs for a
Most likely the ignition coil or DIS System is not shorted out, but disabled. This vehicle is equipped with a passkey security system. What this system does is disable the spark to the engine if the computer thinks that the car is being tampered with. The problem can usually be traced to the ignition switch. This is where the passkey sensor is located. Usually replacing this sensor or full ignition switch will take care of the problem. On some occasions though they are few and far between a replacement key cut at the dealership may allow the system to operate correctly. Do keep in mind, this particular scenario only happens about 1 in every 25 situations. I really hope this information helps you. If not please notify me of the problem, I would appreciate the feedback. Good Luck!
SOURCE: Hy My ignation barrel broke and I replaced with a
key might need to be coded ask in volkswagon garage
SOURCE: cars computer showing immobilizer problem.car will
Dear Sir
It could be cause of 4 things 1 Key faulty 2 Engine Control Module 3 Ignition Immobilizer 4 Wiring.
But when you replacing immobilizer it should be program or paired with Engine Control Module and Key, Then only it will work, for programing you will require scanner or diagnostic tool for particular model, better to visit authorize workshop. if any doubts please feel free and ask me thanks.
481 views
Usually answered in minutes!
guys pls help me!
×