Question about 2000 Mercedes-Benz E-Class

1 Answer

ABS FLASHING ON A E2000 HOW TO RECTIFY THIS

NEW BATTERY FITTED

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Mercedes-Benz Master
  • 2,910 Answers

Most likely low on brake fluid or air in system.

Posted on Dec 06, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my Honda horn keep beeping when connecting negative battery terminal


DOUBLE CHECK that you have connected the battery the right way and haven't put the positive on the negative. This is sometimes a warning that you have the terminals the wrong way round. If the battery is fitted correctly check the fuses.

CHECK THE MARKINGS ON THE BATTERY + & - ARE GOING TO THE CORRECT TERMINALS

May 24, 2016 | 2009 Honda Civic 1.8

1 Answer

Tyre pressure control light is on, but pressure is normal.


It is possibly a flat battery in one or more of the sender units in your wheel or it may have a damaged sender unit if you have had new tyres fitted recently take your vehicle back and have them rectify the problem

Oct 28, 2015 | 2011 Kia Sportage

1 Answer

Clifford intelliguard 950. Won't work properly


Find the manual that came with the system, it will tell you how to reprogram the system after a battery change, these systems are famous for killing batteries if the car is left sitting and not started.

Oct 14, 2012 | Cars & Trucks

1 Answer

Abs fault on nissan micra


if you did not remove the abs sensors before changing the bearings you probably broke then off of them. it happens a lot

Jan 22, 2018 | Nissan Micra Cars & Trucks

1 Answer

Kalos ABS Light stays on?


Hi I had the same problem with my 06 Kalos and it failed the MOT because of the light staying on I tried all sugestions in different forums including new abs rings new brakes etc what worked for me was swithing the ignition key on and off at least six times turning the key alll the way back and then starting the engine the light did not go initially but the next day but this was enough to pass the MOT it came back on after going over potholes but i done it again and it went off and stayed off.

Apr 07, 2012 | 2006 Chevrolet Kalos 1.4

1 Answer

Abs light still dose go off after fitting to new abs sensors?


new abs and speed sensor fitted light still on do codes have to be cleared

Nov 27, 2011 | Cars & Trucks

1 Answer

Air bag and abs lights staying on


If the Airbag light is on, it indicates that a electronic fault is stored in the memory for the airbag. You will need to have a diagnostic check done to pinpoint what the fault is, have it sorted out and only then can the fault be cleared so the light will go off. The ABS light also indicates a fault on the electronic side of the braking system. If the light comes on as you start the vehicle this indicates that there is an open circuit in the wiring or that the ABS control unit itself is faulty. If the light only comes on once the vehicle is in motion, this indicates that a wheel speed sender is incorrectly fitted or dirty and not sensing the ABS Rotor on one of the wheels. If a CV joint has been replaced, the joint may not have an ABS ring fitted on it.[front] At the rear the ABS pick up is fitted on the inside of the brake discs and must be fitted to the new disc when replacing discs.

Jun 02, 2010 | 1998 Audi A4

1 Answer

How to install abs ring?


ABS ring at front fits on CV joint and should come fitted on a new joint. if not fitted, can be tapped on lightly and evenly using a hammer and punch. rear ABS ring fits inside brake drum. when changing discs/drums ring must be tapped off with punch placed through wheel bolt holes to back of ring. to refit tap on to inside of drum.

May 23, 2010 | 1997 Audi A4

3 Answers

Fitted new abs wheel sensor how do you turn off, 850 volvo


Most times, warning lights, engine lights ect, can be reset by disconnecting the battery for 5 minutes or so, but you will also loose any saved radio stations, times, and anything else like that.

Nov 16, 2009 | 1994 Volvo 850

Not finding what you are looking for?
2000 Mercedes-Benz E-Class Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85178 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...