SOURCE: engine timing for a 1998 subaru forester with a 2.5
Since ignition timing is taken care of by the ECU, I guess you are asking about cam timing.
There are several marks to be aligned and if you get them wrong, you may trash your engine so I am only going to suggest you buy a Haynes service manual that has numerous good pix that show you exactly how to avoid killing your engine.
And, unless you have a good-size vice well-mounted, compressing the belt tensioner again is going to give you fits.
The Haynes number you need is 89100 but it is listed only as a manual for the Legacy which uses the same engine but there may be less info that is usable on your '98 forester for which Haynes does not make a specific manual.
The later book that I have, 89101, covers all models from 2000 to 2006.
SOURCE: subaru forester heater
take back to the dealer,hopefully the will find that the blend door cable is off or not adjusted properly
SOURCE: 2000 subaru forester ignition coil wiring
Are there any other possible problems, or you are just not receiving spark at all now?
The coilpack could be dead and just need replaced. If you have a voltmeter or a test light, check the wiring on both sides of the coilpack harness to make sure it is receiving power.
I don't believe Subaru used ignitors past '99, but if they did, your should be located on the firewall behind the throttle body. Make sure it's plugged in and receiving power.
Coil packs do go bad from time to time. I had to replace mine in my
'98 Impreza a while back.
Goodluck!
SOURCE: subaru forester 2001 has a slow acceleration.
how many mile is on the car it could have a bad muffler or possibly need a tune up
SOURCE: Subaru forester (2006) radio stopped
Best guess is the antenna has a broken wire/lead, or somehow got unplugged from the radio. You will have to remove the radio to check antenna wire with Volt/ohm meter.
Testimonial: "Sounds reasonable - will check"
78 views
Usually answered in minutes!
×