Crankshaft position sensor on 2011 malibu

P0010, P0011 (Intake/Exhaust Camshaft Solenoid) 2013 Chevy Malibu
https://www.youtube.com/watch?v=-RhsWasBAXA
Replacing a Camshaft Position Sensor on a Chevrolet 2.4 Ecotec P0340
https://www.youtube.com/watch?v=uF9l2gtDYIk
GM 2.4 Ecotec Camshaft Position Sensor - How To Test & Replace
https://www.youtube.com/watch?v=dOvwSncdP0g
2011 Chevy Malibu 2.4 camshaft senors location
https://www.youtube.com/watch?v=YCNRrv4r2Uk
2013 Chevy Malibu P0014
https://www.youtube.com/watch?v=VLNnc8v8TVw

Diagram shows location.

hope it help

4cyl ltz,crank sensor is located below the oil filter housing,hope this help!

hope this help

The sensor is located behind the starter, next to the oil send switch, the starter must be removed..

P0016 Crankshaft Position - Camshaft Position Correlation
____________
mpps v13.02 car list

CRANKSHAFT POSITION SENSOR IS BEHIND CRANKSHAFT PULLEY.YOU HAVE TO REMOVE CRANKSHAFT PULLEY TO REPLACE THE CKP SENSOR.

if a 2.2 four-cylinder, remove the starter motor. disconnect the 7x crankshaft position wiring and harness connector. remove crankshaft retaining bolt and withdraw sensor from engine block. replace the "O" ring and lightly lubricate it with new engine oil. installation is reverse of removal. have a good one !!

on 2.2 models remove starter. disconnect 7x crankshaft position sensor wiring harness.remove sensor mounting bolt, with draw sensor, replace o ring and lightly lubricate it with oil.... on 6 cylinder models,..remove the drive belt, jack up car, remove crankshaft pulley. remove sensor bolt and pull out.( noting the wiring harness for installation).