On my 1999 chev silverado the power mirrors and my

How to fix the Chev power window door lock switch - YouTube

? 5:04
https://www.youtube.com/watch?v=XDKaDURD8Sc
Jul 13, 2013 - Uploaded by spelunkerd
How to fix the Chev power window door lock switch ..... Some time later my drivers side window stopped working in the down position. ... These intermittent electrical problems are frustrating,aren't they? .... How To Install Replace Door Locks Chevy GMC Truck Silverado Sierra Yukon Tahoe Suburban ...

Diagnose Power Door Locks Dont Work Properly - Auto ...

www.auto-repair-help.com/.../diagnose_power_door_locks_dont_work_...

An inoperative power door lock can be caused by the switch, solenoid, wiring problem or ... Hi, I have a 2005 Nissan Sentra and the power locks aren't working. .... Hi, mypassenger door locks/unlocks both doors but my driver side door works independently and .... I have a 1986 Chevy Silverado K10 with auto door locks.

SilveradoSierra.com • 2003 silverado no power in right door ...

www.silveradosierra.com/.../2003-silverado-no-power-in-right-door-t30...

Beings as everything that stopped working is on the passenger side, I'd think some wiring got disconnected or broken.

check fuses and relays if there good then there is a short in wiring open door and check wires make sure that they aint pinched or any broken wires on side of door between the fender should be a big harness with a rubber insulation.

First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514

try to reset it again . might be your body control module , may need replaced

Check your fuses!

sounds like you have a bad ground somewhere. Check every ground strap that you can find, make sure it's tight, and not corroded, etc. Sounds like the accessories are trying to find a ground, and going through the brake light to do so, thus burning out from too much current.

The doors locks and mirrors may be a blown fuse.

The window is simply a window lift motor that is either worn out and ready to go, or the tracks need cleaned and lubed...but most likely its the motor

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

Your chevy uses two fuses for the system. The power lock actuators are on the 15 amp fuse inside the truck. The fuse for the switches (locks and mirrors) are under the hood. For 99 to 04 (I think those are the years) there is a TSB on replacing the 3 amp fuse under the hood with a 5 amp fuse because this is a well known problem of having these blow.

Your drivers side window is a different issue. If the rest are working your problem is in the motor or getting power to the motor. The wires that go from the body to the door often crack and break with the opening and closing of the door.