Adjust Headlights Horizontally in Hyundai Sonata 2002

Question edited for clarity.
Question moved to model category.

In the link for videos

https://www.google.com/search?q=2008+Hyundai+Sonata.+How+to+adjust+headlights

..

Hi Angela, look behind the headlamps and you will see a cog like wheel with a small bolt in the middle (below the headlamp harness). use a small ratchet or spanner to turn the whell left or right for up and down to lift or lower the headlamp.Place you vehicle facing something that is white and turning the bolt slowly you will note the headlamp moving up or down. Hope this is helpfull info as that is how i sorted mine out.

The dealer should be happy to adjust your headlights to your satisfaction

take it to a garage, there are ajusters on the back of each lamp that you twist with a screw driver

The headlights are supposed to turn off when you remove the key and open the door. It happens automatically.

The headlamps are adjusted by a wheel which can be operated by aphillips screwdriver. There's a hole in the top of the headlamphousing or radiator support which leads to the wheel with little teethon it on the back of the headlamp. The lamps on your car emit a veryshort but wide beam, so no horizontal adjustment should be needed.


http://www.automedia.com/Aiming_Headlights/ccr20010801ha/1

hi from uk have a look directly under the alternator ? oil filter screws direct ino side of engine horizontally and is a small cylindrical type

there is an adjustment screw on the back of the headlamp assembly. check the bulb and make that is installed straight with the metal tab lined up inside the hole.

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

HEAD LAMP AND FOG LAMP AIMING POINT