2004 ford sport trac 4x4V6-transmission type 5R44E Deceleration to a stop delayed shifting from higher gear 3rd? too1st not shifting soon enough so when stopping at times delayed in shifting into1st will stall out.What is the issue to fix & replace whats parts (sensors?) other than that everthing tis to be okay what parts do I need to replace to resolve this problem.

SOURCE: 2002 Ford Focus and Wacky Speedometer

you can use the ford fault codes to check with out going to a dealer this may reset the poss ecu fault
easy check system without a laptop ?? as long as you have a digital trip
before you start your car press and hold the trip reset button turn the key to start your car and keep the button pressed within 10 seconds the clock will show 0000 when this appears each time you press the trip button it will self test differant systems full dash clock sweep all warning lights engine rpm alternator charge engine core temp fuel flow and will list fault codes which can be checked on this site atleast it will save you afew quid/euros dollers on ford checking it for you and you will know what if anything needs doing i hope this helps

SOURCE: 2002 Ford F150 5.4L hard shifting

Have you ever changed the transmission fluid flush and replaced the transmission filter?

SOURCE: how to replace fuel filter on 2001 ford sport trac

Buy a manual and read it. The manual will tell you how to replace...

SOURCE: Ball joint replacement-2003 Ford Sport Trac

I have removed my lower right ball joint nut jacked up the truck by the lower control arm and used the pickle fork and it still will not seperate. what next?

Marvin

• 85242 Answers
• Posted on Oct 23, 2010

SOURCE: Code: P0340 Cam shaft position

Causes

A code P0340 could mean one or more of the following has happened:

• a wire or connector in the circuit could be grounded/shorted/broken
• the camshaft position sensor may have failed
• the PCM may have failed
• there exists an open circuit
• the crankshaft position sensor may have failed, yes the crank sensor can set this code as well

With a P0340 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:

• Visually inspect all the wiring and connectors in the circuit
• Check for continuity in the circuit wiring
• Check the operation (voltage) of the camshaft position sensor
• Replace the camshaft position sensor as required
• Check the crankshaft position circuit as well
• Replace circuit wiring and/or connectors as required
• Diagnose/replace the PCM as required