Had front wheel bearings replaced now a.b.s. light is on and cruise not working.
SOURCE: 1998 Jaguar XJ8 front wheel bearing
it does press out/in, but they can get stuck. u are using a hydraulic bearing press?
SOURCE: Rear interior light and door courtesy lights not working- Jaguar
take off the cover and replace them. if you have a volt/ohm meter you can put if on the car side and make sure you have voltage and the ohm meter on the buldb should give a 1 rating if its good. it would be the cheapest and easiest to just get a new bulb and see if it works then start checking fuses if its not the bulb.
SOURCE: need to replace the left front wheel bearing on my wife's car
Too bad I am not at work I could call on a price for a bearing. To be honest that is not too bad of a price on a bearing installed. Most Jag parts need to be purchased from Jag. A typical price for a sealed hub bearing unit is about $140 retail for a chevy corsica(just did 2 on one on monday) to about $300-400 on a ford super duty. and that is not including labor. You need air tools, a torque wrench and lock tight thread locker for this job. And something to remove any corrosion from mounting surfaces
1. jack up car,take wheel off.
2. remove brake caliper
3.remove rotor
4.remove whats holding bearing on. Either one big nut on outside or three to four bolts that hold it to the knukle.
this is how most cars are now,if its rear wheel drive its a peice of cake ,fwd is a little more difficult.
SOURCE: how to replace rear wheel bearing on s type jaguar v reg
pretty basic the same and any other wheel bearing. But you need a hydraulic press, if you dont have one of those then their is just no way that you will be able to do it.
If it is newer than an 05 you need to take it to the dealership, because they need to hook up their computer and electronically disengage the rear parking brakes by putting it into service mode.
SOURCE: Cruise control unavailable--x type Jaguar
I had the same problem and found that the PCV breather hose was leaking, creating the vacuum leak. The codes for the error have translated to "bank 1 too lean, and bank 2 too lean." Start with the PCV breather hose and see if that doesn't fix it. You will also have to reset the computer afterwards to get rid of the error.
430 views
Usually answered in minutes!
×