SOURCE: audi A3 2006
there is a square plastic box on the right hand side of the car under the bonnet, there is about 4-6 screws around the box , remove them , pull at the top section and it will come off,replace filter and replace screws, make sure all plastics are replaced , ant it is a good idea to hoover out box when filter is removed .
SOURCE: Audi A4
Not sure if they've changed it but this is what i do for my 99 a4
First remove the screw in the handle pull, it should be next to where your fingers go.
Pull down on the black piece of plastic and remove the screw form the door
Then remove the screws on either end of the door, one near the door jam on top and one near the other side, same place.
Finally pull up then out and the door panel should come out
Hope that helps
SOURCE: remove/replace wing mirror on audi 80
take off the plastic cover on the upper forward corner of the door, you will see three bolt studs with nuts..Remove the nuts, pull the mirror out enough to disconnect the electrical connector.
SOURCE: audi a3 r reg remove inner door panel drivers side
On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls.
SOURCE: remove thefront door panel on the driver's sidd in
you have 2 sicrews ( small) near the glass left and right to open & pull the panel upwards 1.5 cm then the panel becomes free .
46 views
Usually answered in minutes!
×