Check engine code p0506 - 2003 Honda Accord 2.4 LX

P0306 is a misfire on cylinder #6 P0174 is a lean code for bank 2 ,P0506
https://www.obd-codes.com/p0506

Check Engine light Code P0506 Throttle Body Idle Air Control (IAC) System RPM Lower Than Expected, Do not waste your money Solve the problem of code Throtte Body P0506 with three dollars video Part #1 Remove Throttle Body

P1336 Crankshaft and camshaft sensors out of sync
If you get this code, the first thing to check is your distributor especially if you have an imported vehicle. Look for signs of oil in the distributor which can contaminate the signals being monitored by the ecm (engine computer).Check also the wiring leading to the distributor and see if the wires are properly insulated away from hot exhaust which could burn the wires. Do these checks also on the crank sensor itself whether it is located in the front of the engine or at the flywheel at the rear of the engine. Ditto for the cam sensor.

On engine with distributor, the cam sensor is usually located in the distributor and it will give you a lot of grief if not properly align and synchronize with the crank sensor. On some applications (like Ford), an alignment tool is required which is can be bought from your local parts store (cost about $31). If you install the distributor without proper timing, it will still run but the mileage will suffer and the above code showing up.


P0506 - Idle Air Control System RPM Lower Than Expected
This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.
Potential Symptoms

Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
A vacuum leak
An air restriction in the intake air path or exhuast
A faulty positive crankcase ventilation (PCV) valve
Damaged/failed/dirty throttle body
Internal engine problem
Failed PCM

Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.


Hope this helps (remember to rate and comment this answer).

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.
Potential Symptoms Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.
Causes A P0506 DTC trouble code may be caused by one or more of the following:

• A vacuum leak
• An air restriction in the intake air path or exhuast
• A faulty positive crankcase ventilation (PCV) valve
• Damaged/failed/dirty throttle body
• Internal engine problem
• Failed PCM

Possible Solutions This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

P0506 - Idle Air Control System RPM Lower Than Expected
This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms: Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
A vacuum leak
An air restriction in the intake air path or exhuast
A faulty positive crankcase ventilation (PCV) valve
Damaged/failed/dirty throttle body
Internal engine problem
Failed PCM

Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

Other related DTCs: P0507

Hope helps.

Chequea el cuerpo de aceleraci?n y la v?lvula IAC pueden estar sucios, que los limpien y revisa los inyectores lavalos tambi?n.

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms: Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* An air restriction in the intake air path or exhuast
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Internal engine problem
* Failed PCM

Possible Solutions:
This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.


Suerte.

Hi:
Here is info on your code:

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

What does that mean?
This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms: Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* An air restriction in the intake air path or exhuast
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Internal engine problem
* Failed PCM


The first thing to do is clear the code and see if it comes back, and if it does, work your way thru the list of possible causes.

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms: Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* An air restriction in the intake air path or exhuast
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Internal engine problem
* Failed PCM

Possible Solutions: This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

Hope helps.

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

What does that mean?
This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms: Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes: A P0506 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* An air restriction in the intake air path or exhuast
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Internal engine problem
* Failed PCM

Possible Solutions:
This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.

Other related DTCs: P0507

P0506 - Idle Air Control (IAC) System RPM Lower Than Expected

What does that mean?
This P0506 code is one that's sometimes triggered on vehicles that have electronic throttle control. That is, they don't have a regular throttle cable from the accelerator pedal to the engine. They rely on sensors and electronics to control the throttle. In this case, the P0506 DTC (diagnostic trouble code) is triggered when the PCM (powertrain control module) detects an engine idle speed that is lower than the desired (pre-programmed) RPM.

Potential Symptoms
Most likely the only thing you'll notice is the idle speed is lower than normal so it will likely be rougher. There are potentially other symptoms as well. Of course, when trouble codes are set, the MIL (malfunction indicator lamp, a.k.a. the check engine light) illuminates.

Causes
A P0506 DTC trouble code may be caused by one or more of the following:
* A vacuum leak
* An air restriction in the intake air path or exhuast
* A faulty positive crankcase ventilation (PCV) valve
* Damaged/failed/dirty throttle body
* Internal engine problem
* Failed PCM

Possible Solutions
This DTC is more of an informational code, so if there are any other codes set, diagnose them first. If there are no other codes, inspect for vacuum leaks, restrictions, and damage. If there are no symptoms other than the DTC itself, just clear the code and see whether it returns.