SOURCE: 1996 HONDA ACCORD CRANKSHAFT SENSOR AND CAMSHAFT SENSOR.
befor in the ealier models of accords they use to be both the cam and crank sensors in the distibutor but they separated them !!!So no they are not together on your car tha cam sensor is in the distributor and the crank sensor is in front of engine or in the lower timing belt cover if it is in the timing cover you can see a wire going dow the timing cover way to the bottom on the rear side off it
hope it will help you if you have any question just wright back !!!!
Denis
SOURCE: Where is the camshaft position sensor located-99 Chevy Lumina 3.1
It's held down by one bolt right above the timing chain cover. It's next to the head that's facing toward the front of the car.
SOURCE: 97 Chevy Astro van lugs, like it misses, B4 finally cranking on
crank shaft sen. is easy enough to change.its mounted near timing chain cover,cam sen.is somewhat harder,its in the distributor,id doubt that both are defect
SOURCE: trouble code P0105 continues to set on 2003 chevy trailblazer
If you have bearing problems MAP sensor codes are the least of your worries. Check on the cost of getting a new engine. I hope this is not the problem. Good luck Moe
SOURCE: I need to know were the camshaft position sensor
look on the side or rear of the engine in the area of the cam it will be in close proximity to the cam it is usually recessed into the engine block but can also look like a relay but it will have a wire harness plug on it also its usually located any where from the midle of the engine to the right side front or rear.
107 views
Usually answered in minutes!
i have replaced both and it still dont start it fires and has 59psi of fuel pressure
×