1993 Olds Cutlass Supreme S
Both Turn signals light, but do not blink
Fuses are good
Bulbs all good
Turn Signal flasher replaced
None of these fixes have worked
Multifunctiion switch. Is it in the steering column and how do you go about replacing it?
My turn signal flasher was located to the right of the ash tray, I looked around the column for HOURS and it wasn't there... I also have an 93 oldsmobile cutlass ciera, it drove me crazy because the manual wasn't correct.
Are both signal on at the same time. If they come on like they should but just don't blink it is more likely a bulb or a flasher, not the switch. The Turn signal switch is in the column. You have to remove the steering wheel and lower dash cover, but you don't have to remove or completely disassemble the column.
Make sure you replaced the turn signal flasher and not the hazard flasher. They look exactly the same. Turn on your hazards and listen for the click, that way you can determine that the other flasher is for the turn signals. The turn signal flasher is usually attached to the steering column near the brake pedal.
×
1,079 views
Usually answered in minutes!
Just change out turn signal switch. Passenger side bulbs(front and rear) light when the right turn signal should be flashing. However there is no flashing, clicking...Now, what should I consider at this point. Before I changed out the turn signal switch the problem was: the passenger side would occasionally light but would not flash I had to flash them manually. Also, the brake lights would not illuminate when the brakes were pressed. The brake lights work fine now.
Not afraid to do it myself.
[email protected]
1996 Cutlass Oldsmobile Supreme...Just changed out turn signal switch. Passenger side bulbs(front and rear) light when the right turn signal should be flashing. However there is no flashing, clicking...Now, what should I consider at this point. Before I changed out the turn signal switch the problem was: the passenger side would occasionally light but would not flash I had to flash them manually. Also, the brake lights would not illuminate when the brakes were pressed. The brake lights work fine now.
Not afraid to do it myself.
[email protected]
there are two flashers your hazards and your turn signal flasher, make sure you replace the turning flasher. it is normally located under center of dash(behind ashtray radio) or on drivers side by parking brake. if that isnt working then check the ground wires on your lights sometimes if they arent grounded properly the signals wont flash.
if your fusebox is in the glovebox area then your turn flasher is on the left and the hazard flasher is on the right.
also check to see if you have any bulbs out in front and rear including heatlights and upper and rear brake lights
×