How to replace fuel pump bmw 1996 z3 - 1997 BMW Z3 Roadster

SOURCE: Will the wheels from a BMW Z3 M fit a 1999 BMW Z3 2.8 ltr roadster?

yes they will you just may need to use a wheel spacer

SOURCE: what is the normal price for a 1996 bmw z3 hood

should be around $400

SOURCE: How do you replace the hood badge? 98 BMW Z3

Allow some warm water mixed with dish soap to penetrate around the edges of the old ornament. Gently slide a pry tool into the top or bottom center. The hold downs (plastic clips that SHOULD pop) are going to be on the left/right middle. While continuing to pour some warm water and dish soap around the pry point, work the pry tool around the circle. If you don't have a pry tool, use a non-ridged butterknife wrapped in electrical tape. It will take some force to remove, but it will come out.

Please note, you CANNOT re-use the clips. Your new hood ornament should have some with it.

Remove ALL old adhesive from the paint surface so that the new ornament will go on smoothly. Best of luck!

SOURCE: 1996 bmw z3 1.9. It stalls while driving and won't start again

Hi this is not going to really help but i have sort of the same problem when i have been out in my car, get back in and turn the key.... nothing ,dead well seems that way , but turn the key again and it starts the battery is new 1year old but this happens about once every couple of weeks never happens when the car is cold ! starts first time then . Is this the same as you .My garage said it could be the ignition switch but they say it could also be earthing ,which they will check first . My car is 1998 model 1.9 . Sel

SOURCE: How to replace/install a fuel pump on a 1997 BMW

Installing a water pump. Courtesy of Dana Corporation.

• Loosen and remove the bolts in a crisscross pattern from the center outward.
• Insert a rag into the block opening and scrape off any remains of the old gasket.

• When replacing a water pump, always follow the procedures recommended by the manufacturer.
• Most often a coating of good waterproof sealer should be applied to a new gasket before it is placed into position on the water pump.
• Coat the other side of the gasket with sealer, and position the pump against the engine block until it is properly seated.
• Install the mounting bolts and tighten them evenly in a staggered sequence to the torque specifications with a torque wrench. Careless tightening could cause the pump housing to crack. Check the pump to make sure it rotates freely.
• The water pumps on many late-model OHC engines are driven by the engine's timing belt. When replacing the water pump on these engines, always replace the timing belt.
• Make sure all pulleys and gears are aligned according to specifications when installing the belt. NOTE THIS IS FOR A 1.9 4CYL