I need to know where the crank shaft censor located in a 2002 hyundia accent 1.6 L

SOURCE: replacing clutch in 2002 hyundia accent

are you doing this on the ground or on a lift

SOURCE: crank positioning censor

The camshaft position sensor is located on the timing cover on the front of the engine. The crankshaft position sensor is located just above the differential on the transaxle bell housing where it has to be to read from the flywheel the position of the crankshaft. It is easy to see from the front of the engine even though it is on the back half. Just look for the shifter cable and where its bracket ends (on the firewall side of the bracket) glance about 12" to the left and you should have no problem finding it. An 8 mm bolt is holding it in and with that bolt taken out it just pulls out of its hole. Google "95 caravan crankshaft position sensor" and then pick IMAGES so you can see an actual picture of what it looks like.

Marvin

• 85242 Answers
• Posted on Apr 20, 2009

SOURCE: location of a sensor

Replacing a CPS can be easy or hard. On the 2002 Gallant 2.4, it is located behind the timing belts. Removal of the main pulley, the covers and the belts is required. This isn't as hard as it sounds and is essentially the same as changing the timing belts.

PAUL MC G

• 1280 Answers
• Posted on Oct 04, 2009

SOURCE: where is the pcv valve located on a hyundia 2002

Back side of the vallve cover (cam cover)

Greg Bernett

• 2993 Answers
• Posted on Oct 13, 2009

SOURCE: i need instructions on how to change a crank shaft censor

3.8L Engines

1. Disconnect the negative battery cable.
   
2. Remove the serpentine belt(s) from the crankshaft pulley. Please see Section 1.
   
3. Raise and safely support the vehicle.
   
4. Remove the right front tire assembly. Remove the right inner fender access cover.
   
5. A flywheel holding device such as GM's J 37096 is required to keep the crankshaft from turning as the crankshaft balancer is being removed. Install this holding tool or its equivalent. Please see Section 3 for more information.
   
6. Using a 28mm socket, remove the crankshaft harmonic balancer retaining bolt. Using special tool J 38197 or equivalent balancer removal tools, drawn the balancer from the end of the crankshaft. Please see Section 3 for more information.
   
7. There is a roughly circular aluminum shield that protects the crankshaft position sensor; remove this shield. Use care not to damage it. Do not pry to remove.
   
8. Detach the electrical connector from the crankshaft position sensor, remove the attaching bolts and separate the sensor from the engine block face.
   

1. Clean all parts well. Position the crankshaft sensor to the block face and tighten the bolts to 14–28 ft. lbs. (20–40 Nm).
   
2. Install the crankshaft position sensor shield. Verify that the electrical connector is secure.
   
3. Install the crankshaft balancer. Please see Section 3.
   
4. Torque the crankshaft balancer center bolt to 110 ft. lbs. (150 Nm), plus an additional 76 degrees.
   
5. Install the inner fender access cover and the right front tire assembly. Wheel nut torque is 104 ft. lbs. (140 Nm).
   
6. Lower the vehicle.
   
7. Install the serpentine belt(s), as outlined in Section 1.
   
8. Connect the negative battery cable.
   

Testimonial: "thank you for this i couldnt find any other info that made as much sense to me as tis so once again thanks"