Might be the Resistor pack located close to the blower. Could be under the dash or under the hood, but always close to the blower itself. Usually has a flat connector with 4 or 5 wires, and two small screws holding in the duct. It may be a crispy critter. It happens... The blower moves air across it to keep it cool. The blower motor may be bad as well, or possibly the fan speed switch. May very well be the fuse for the blower as well. The blower connector may be loose. Let me know what you find.
SOURCE: 2004 monte carlo sunroof won't close
THERE IS NO MAN OVERIDE, REMOVE THE DRIVE MOTROR AND THE SUNROOF WILL CLOSE.
SOURCE: 2000 monte carlo how to replace water pump.last bolt
there should be holes in power steering pump pulley that when positioned correctly the bole should go through one of those holes, if not then you have to remove the pump
SOURCE: replacing heater core on 2004 monte carlo
REMOVAL PROCEDURE 1. Remove the fuel injector sight shield. 2. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System. 3. Use J 38185 in order to position aside the heater hose inlet and outlet clamps at the heater core. 4. Disconnect the inlet and outlet heater hose from the heater core. 5. Remove the RH Instrument Panel Closeout/Insulator panel. 6. Remove the LH Instrument Panel Closeout/Insulator panel 7. Remove the floor carpet. 8. Remove the rear floor air outlet duct from the holes in the floor reinforcement. 9. Disconnect the rear floor air outlet duct from the heater air outlet cover. 10. Remove the rear floor air outlet duct. 11. Remove the heater air outlet cover screws (2). 12. Remove the heater air outlet cover heat stakes (1) with a small chisel. 13. Remove the heater air outlet cover from the HVAC module assembly. 14. Remove the heater core cover screws (2). 15. Remove the heater core cover heat stakes (1) with a small chisel. 16. Remove the heater core cover from the HVAC module assembly. 17. Remove the heater core from the HVAC module assembly. 18. Remove the heater core foam seal (1) from the HVAC module assembly
SOURCE: car wont stay running, think its carb problem
If I understand correctly the car will idle but will not drive unless you pump the gas. If that's the case then you need to have it overhauled. There are blocked lines inside that are preventing it from working properly. Hope this helps.
112 views
Usually answered in minutes!
×