My accent stalls at stop signs and lights, will start back up. Battery has been checked its ok. Does not backfire, When it dies the lights flicker. I took to Auto Zone connected the diagnostic tool and it displayed the following codes P0717, P0734. P0732, and P0108. Please help. Thanks
SOURCE: I have a 2005 Hyundai
Definitivelly the trans is going bad and slipping. Thats what the codes mean. Theres not much that can be done from the outside. If you choose to fix it, id go with a good used to keep costs down. You can locate one at www.car-part.com
All codes are for the trans slipping. If a sensor was out, you would have certain codes that say which one.
For instance if a speed sensor was out, you couldn't have the two codes
you have now as the speed sensor has to work in order to generate your
codes now.
I would check your fuses. Check the connector to the transmission check
the harness for any chaffing against the trans case where the wires
could be shorting out. If all of that looks okay I would check the
internal harness by removing the trans pan then replace the valve body
which includes all of the solenoids. If all of that doesn't work its an
internal failure and the trans must come apart for inspection and
repair. As a rule of thumb if its intermitant its probably electrical
if it does it at all times it could also be internal.
Keep us updated.
SOURCE: My 2001 Hyundai Accent 1.5
See if your idle air control valve needs to be cleaned out. This is a common problem in cars that stall out a lot.
SOURCE: Hyundai Accent (2000) Engine stalled.
Does it have fuel in the injectors line? It could be the fuel pump!
554 views
Usually answered in minutes!
×