Camshaft position sensor 2.2 subaru legacy outback 1996 location

autodr

• 260 Answers
• Posted on Nov 22, 2008

SOURCE: 2005 Subaru Legacy: Where are the O2 sensors located (both)

the o2 sensors are locted in the exhaust system. upstream is before cat converter, downstream is after cat converter.

SOURCE: were is the starter located in a subaru legacy

On the drivers side where the motor and transmission join on the top, you should see the starter. Your main hot or red battery cable should lead right to it. It has 2 bolts holding it. 1 is the bolt to hold starter and trans together, the other just holds the starter. Hope this helps and have a great day.

SOURCE: 1997 subaru legacy outback knock sensor location

Hiya,

Here you go:

2.5L Engine To Remove:

1. Disconnect the battery ground cable.
2. Remove the air cleaner housing.
3. Vehicles with 5-spd transmission: Remove the clutch slave cylinder and set aside.
4. Disconnect the knock sensor wire harness retainer from the coolant hose.
5. Disconnect the knock sensor (KS) wire connector.
6. Remove the mounting bolt and knock sensor from the engine block.

SOURCE: how to set timing on a subaru outback legacy 2.2

ignition timing is not adjustable,
the valve timing marks are at 12o'clock on both camshafts and crankshaft

SOURCE: I am needing to replace the fuel relay switch on

my car wont start ive changed plugs and fuel pump and now ive been told it could be the relay switch but dont know where it is of if it is that any suggestions and my car is a subaru impreza 93