Showing codes po325, po340
SOURCE: start runs rough short time then shut off
simply replace distributor cap and rotor button, wires and plugs. that will fix it
SOURCE: trouble codes and why
my check engine light has been on for a few months and now my oil light flickers. what doesn this mean?
SOURCE: DTC - PO340, PO325
My Nissan micro 2004 model just stopped in the middle of the road one day then the engine management light came on, anyway took it to my local garage TWK Thomas who said it was a cam shaft sensor problem. OK so sensor was put on, engine management light went off for two days only. So went back to the garage they said that another sensor should be fitted on the opposite side. And then the problem should be rectified, but i had given the £160 for this problem to be fixed the first time. I decided it was time to take it to another garage Nis Tec they put it on the computer and a code po340 came up would this mean another sensor or the cam chain has stretched please help. ...claire
SOURCE: car will not run, got two DTC's po340 and po325
The po340 is a cam sensor code ,po325 is a crank sensor code>THE crank if it goes bad will through both codes,and also the car will not start.You will have no spark or injector pulse.So have your crank sensor checked:)
SOURCE: trouble codes po340,po605.and po325 car will
po325 knock sensor 1 malfunction po340 camshaft position sensor malfunction po605 internal control modular (rom) read only memory error check the wiring to the computer for proper connection and damage the computer (pcm) may be damaged or its program erased this happens sometimes when the connector is unplugged and the battery is hooked up the other two can be related (pcm) failure or could be a wiring problem po325 check knock sensor wiring and sensor and same for po340 crank sensor wiring and sensor good luck
81 views
Usually answered in minutes!
×