We have a Hyundia Elantra 2002. The past few months after a fill up for a few miles the engine runs ruff at idle. Also the Idle has been around 400-500 rpm in gear with the brake on. We had it to the dealer and it shows nothing on the computer. They also checked the charcol filter from the gas tank vent and that appears ok. What do you think. I've now been using some gas additives and a Shell type gasoline... Thank You, Bob
Sounds like the fuel pump is starting to go, the problem after fill up is most always related to a failing pump. The other issue may be a dirty throttle valve.
SOURCE: how do you get rotor off 2003 hyundia elantra
hi from uk not sure if same as uk hyundai's but here goes ? if you remove wheel do you see two countersunk posi screws between studs that appear to hold rotor ?? if so then you will have to first remove the brake caliper assy by unbolting from the rear of caliper two 13 mm spanner/socket ? then you remove the two bolts that secure the carrier that the caliper bolts to 17 mm spanner/socket now you can remove the two contersunk screws then you may have to tap the rotor off the hub from rearuse a wire brush to clean up/away all rust/dust from caliper and carrier assys b4 refitting (take precautions from breathing dust) i assume you are fitting new pads ?? reassemble carrier then b4 fitting pads smear a light coating of copper grease on the rear of pad (metal side ) this prevents squealing on brakes then fully reassemble then b4 fitting wheel? bleed the brakee caliper a couple of pumps should expel dirty fluid then fit wheel carry out same proceedure on other brake assy as above fully then b4 you move car pump brake to ensure pedal is firm you will find that bleeding brakes will make pedal firmer as the old fluid becomes compressable due to heat/moisture absorbsion over time and heat from brakes is transferred to fluid via caliper piston understand?? that is why alway policy to bleed/flush brake fluid at least two yr interval this reduces spongy brake pedal hope this is all clear 4 you to follow best wishes for new year and hope you update on how you go on??
SOURCE: taillights for 2001 hyundia elantra
its real easy open trunk lid take rear sill off should just pop off then take trim panels each side then there are 4 bolts each side 10mm tkae bolts out firmly pull on tail lights they should come out and then reverse back
SOURCE: 2001 HYUNDIA ELANTRA AUTO TRANS THE TRANS
You really need a test drive by a tech. Any shop should be able to do that and give you a firm (written) estimate. It might not be a big deal. Shop around if you need a rebuild, If you need one, ask about their warranty. Believe it or not, a good reference for a tranny shop is the Used Car Manager at the Hyundai dealership. Go in to ask him, not over the phone, and be nice. You're asking for a favor after all. Many dealers do a lot of their work outside the store for reasons of cost. It all depends on the dealership. One will, one won't. Ask.
SOURCE: fuel coming out of charcole canister
you hooked the return fuel line to the vent line . need to go back and check your work
SOURCE: 2002 hyundai elantra gls . low idle speed, check
Did the 'Check Engine' Light come ON? Whenever the 'CHECK ENGINE' light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on. You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE and perhaps eventually fix the problem.
107 views
Usually answered in minutes!
×