Spark plugs 2000 cad dts, where are they? how hard to do?

It's actually the number three plug that is behind the steering column. They make a special socket just for this plug. Wharf you spark plug socket has a hex end on it than install it and use a wrench to turn the plug out. It is tedious but it will work. If you spark plug socket does not have the hex end than you can either get one or get the special tool. If you jack up the drivers side of the vehicle by the fframe you can access all the plugs a little easier through the wheel well opening. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

It's actually the number three plug that is behind the steering column. They make a special socket just for this plug. Wharf you spark plug socket has a hex end on it than install it and use a wrench to turn the plug out. It is tedious but it will work. If you spark plug socket does not have the hex end than you can either get one or get the special tool. If you jack up the drivers side of the vehicle by the fframe you can access all the plugs a little easier through the wheel well opening. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

DO SPARK PLUGS AND WIRES CHANGE IF NOT HAVE DONE TUNE UP IN A LONG WHILE. CLEAN FUEL INJECTORS.CLOGGED FUEL INJECTORS WILL CAUSE CYLINDER MISFIRE ALSO.

Spark plugs are located on drivers side of engine and passenger side of the engine. Follow the distributor wires coming off your distributor cap. You will not be able to easily access all of your spark plugs from the top. For those pesky hard to reach spark plugs it is advised that you go through your wheel wells. You may have to remove the plastic shroud (or cut a hole in it).

No. Remove the covers on the top of the heads(straight black covers, usually they say Volvo) and that should give you access to the spark plugs. Plug gap is 0.030".

these are all the tools you will need but the one i think your looking for is a long bendable extension

power steering pump is/may be going bad or the rack and Pinion unit could be bad.

No special tools required. Spark plugs or glow plugs mount down into the engine from the top. Last resort - follow the wires. Be careful when changong the plugs such that you don't break any of the wires. The wires are somewhat expensive, and break easily.

Most likely spark plugs and wires. Coils usually kill two cylinders at the same time. Use only ac delco parts. trust me, it is something you don't want again soon.

They're accessible through the top of the engine - open the hood and the spark plug wires should be very easily visible on top of the valve cover. Pluck them out and the plugs are below.