2003 Audi A4 Cabriolet Logo

Related Topics:

Lynette George Posted on Mar 06, 2013

2003 audi a4 PRND lights flashing and reverse goes limp

PRND lights flash on/off sometime all off and putting it reverse goes limp happened twice

5 Related Answers

Anonymous

  • 25 Answers
  • Posted on Feb 18, 2009

SOURCE: audi dash lights

If it is the display for the gears flashing, this indicates a fault with the gearbox system, this is more common on multitronic gearbox's

Ad

Anonymous

  • 94 Answers
  • Posted on Feb 18, 2009

SOURCE: Gear Selection Audi A4

GEAR LINKAGE ADJUSTMENT IS UNDER GAITER PLUS REMOVE ASHTRAY .......BUT I WOULD CHECK FOR WORN OR DAMAGED GEAR LINKAGES ....CLUTCH FAULT WOULD BE THE NEXT THING

Anonymous

  • 1 Answer
  • Posted on Jul 11, 2009

SOURCE: Audi A4 need to replace rear brake light on audi a4

Inside the boot is a plastic cap embeded in the boot liner. Remove the cap to reveal a screw. Undo the screw and the whole rear light cluster will come away in a sideways and not rearward direction to reveal all of the bulbs. Hope this helps.

Anonymous

  • 1 Answer
  • Posted on Jan 25, 2010

SOURCE: AUDI A4 2003 1.8T TRANSMISSION CONTROL UNIT

i have a transmition problem on a 2003 audi a4 1.8t whit 44000klm.
audi is changing transmition at no cost but have to paye for labor

Anonymous

  • 2 Answers
  • Posted on Dec 29, 2010

SOURCE: last night the information display was flashing

This is just to warn you that you have been driving for more than 2 hours and you might need a break. The solution is to press the right hand side (WIPER HANDLE) lower button and the flashing light will disengage. Good luck.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

A light of a whole car came on in my dashbroad in my audi A4 2003 what is that

Engine management light.sometimes it will reset itself when you identified the problem.sometimes it will go into limp mode as well.so if it still drives normally get it to a garage who can run a quick OD11 ecu test to see what error codes are stored on ecu of car.it may be simple reset required if you addressed the overheating issue.
0helpful
2answers

Flashing lights of the PRND and hard shift in Reverse

replace shifting s.w and brake light s.w .try to apply brake many time
0helpful
1answer

CANT GET MY AUDI A4 INTO REVERSE SOMETIMES. ALSO GEARS FLASHING ON DASHBOARD

Do you get the flashing in all gears sometimes or only when it's put in " R " and it doesn't move?
0helpful
2answers

I have a Audi A4 SE 2000 Reg. FE52UFB, with a I believe a Multi-tronic automatic 6 speed gearbox. I have flashing PRND lights. The car runs well, although very occasionally it has dropped out of gear,...

You really should not drive your car in that condition.Resetting codes will not help and it's a waste of money. All indicates problem with torque converter. Service immediately!!!!
3helpful
3answers

Prob's with my Audi A6 2003 Auto 3.0 V6 (gearbox)

Doubt it as the fault suggests you need to look into the range sensor. If similar to Renault there is a switch on the gearbox that senses where the select lever is (at the gearbox end). If the display is wrong then the sensor needs looking at and either it will need to be adjusted into a set position by moving it, or perhaps the connector to it or wiring to/from it have a fault.
0helpful
1answer

My car is an audi a4 automatic sometimes it will not reverse and dashboard gearbox display flashes

Sounds like what happened to our 2004/A4/Cab., twice. both times the dealership replaced the transmission contol module. The second time it was repolaced with about 55,000 miles, out of warranty, I was able to get the dealership to replace this transmssion control module uner the 100,000 mile emissions warranty. So good luck.
0helpful
2answers

My prnd is flashing on and off and the car has no

you have a transmission problem. the tcm has switched to limp mode witch means the trans will start and stay in 2nd or 3rd gear only. this requires a scan tool to properly diagnose the problem. you should get it checked out sooner than later before any further damage is caused by driving it in its limp mode. good luck.
1helpful
1answer

Sometimes can't get reverse gear Audi A6 2004 Auto 1.9TDi UK

Unless your shade tree mechanic is an Audi expert, go to the dealer who has all the books and diagrams that tell the tech exactly where to look. The other guy may want to replace something just to troubleshoot and the factory tech should know exactly what to replace or which plug is loose.
0helpful
2answers

When i put my 2002 audi a6 in reverse it does not actually move when i push on the gas, and the prnd on the computer screen all flashes. what does this mean...

You may have a problem that if you continue to do this, that problem may turn from a $200 problem to a $2200 problem. Get it to a qualified dealer, not a fast fix road side garge.
0helpful
1answer

Cvt

UGH@!@#@$ PRNDS- Limp mode. one of 4 possible issues. Transmission control module ($1000) Valve Body ($1200) Clutch Discs ($1500) or the Housing/ variable disc unit - whole transmission ($3000).... get an extended warranty PLEASE! a good mechanic can pull the codes and tell you what work should be performed. These transmissions ****. Next time QUATTRO ! 
Not finding what you are looking for?

269 views

Ask a Question

Usually answered in minutes!

Top Audi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...